Related Experiment Video

Updated: Jul 27, 2025

Cercosporin-Photocatalyzed [4+1]- and [4+2]-Annulations of Azoalkenes Under Mild Conditions
07:12

Cercosporin-Photocatalyzed [4+1]- and [4+2]-Annulations of Azoalkenes Under Mild Conditions

Published on: July 17, 2020

6.3K

Visible-Light-Mediated Regioselective C3-H Selenylation of Pyrazolo[1,5-a]pyrimidines Using Erythrosine B as

Tathagata Choudhuri1, Suvam Paul1, Sourav Das1

  • 1Department of Chemistry, University of Kalyani, Kalyani 741235, India.

The Journal of Organic Chemistry
|June 11, 2023
PubMed

More Related Videos

[DPEPhosbcpCu]PF6: A General and Broadly Applicable Copper-Based Photoredox Catalyst09:12

[DPEPhosbcpCu]PF6: A General and Broadly Applicable Copper-Based Photoredox Catalyst

Published on: May 21, 2019

9.3K
Efficient Construction of Drug-like Bispirocyclic Scaffolds Via Organocatalytic Cycloadditions of α-Imino γ-Lactones and Alkylidene Pyrazolones10:17

Efficient Construction of Drug-like Bispirocyclic Scaffolds Via Organocatalytic Cycloadditions of α-Imino γ-Lactones and Alkylidene Pyrazolones

Published on: February 7, 2019

7.0K

Related Concept Videos

Photochemical Electrocyclic Reactions: Stereochemistry01:26

Photochemical Electrocyclic Reactions: Stereochemistry

The absorption of UV–visible light by conjugated systems causes the promotion of an electron from the ground state to the excited state. Consequently, photochemical electrocyclic reactions proceed via the excited-state HOMO rather than the ground-state HOMO. Since the ground- and excited-state HOMOs have different symmetries, the stereochemical outcome of electrocyclic reactions depends on the mode of activation; i.e., thermal or photochemical.
Selection Rules: Photochemical Activation
1.9K
Cycloaddition Reactions: MO Requirements for Photochemical Activation01:12

Cycloaddition Reactions: MO Requirements for Photochemical Activation

Some cycloaddition reactions are activated by heat, while others are initiated by light. For example, a [2 + 2] cycloaddition between two ethylene molecules occurs only in the presence of light. It is photochemically allowed but thermally forbidden.
2.1K
Regioselectivity of Electrophilic Additions-Peroxide Effect02:35

Regioselectivity of Electrophilic Additions-Peroxide Effect

In the presence of organic peroxides, the addition of hydrogen bromide to an alkene yields the isomer that is not predicted by Markovnikov’s rule. For example, the addition of hydrogen bromide to 2-methylpropene in the presence of peroxides gives 1-bromo-2-methylpropane. This addition reaction proceeds via a free radical mechanism, which reverses the regioselectivity. The free radical reaction mechanism involves three stages: initiation, propagation, and termination.
8.7K
Sharpless Epoxidation02:57

Sharpless Epoxidation

The conversion of allylic alcohols into epoxides using the chiral catalyst was discovered by K. Barry Sharpless and is known as Sharpless epoxidation. The use of a chiral catalyst enables the formation of one enantiomer of the product in excess. This chiral catalyst is mainly a chiral complex of titanium tetraisopropoxide and tartrate ester (specific stereoisomer). The stereoisomer used in the chiral catalyst dictates the formation of the enantiomer of the product. In other words, the use of...
4.1K
Regioselectivity of Electrophilic Additions to Alkenes: Markovnikov's Rule02:17

Regioselectivity of Electrophilic Additions to Alkenes: Markovnikov's Rule

If a set of reactants can yield multiple constitutional isomers, but one of the isomers is obtained as the major product, the reaction is said to be regioselective. In such reactions, bond formation or breaking is favored at one reaction site over others.
The hydrohalogenation of an unsymmetrical alkene can yield two haloalkane products, depending on which vinylic carbon takes up the halogen. However, one product usually predominates, where hydrogen adds to the vinylic carbon bearing the...
14.4K
Preparation and Reactions of Sulfides02:26

Preparation and Reactions of Sulfides

Sulfides are the sulfur analog of ethers, just as thiols are the sulfur analog of alcohol. Like ethers, sulfides also consist of two hydrocarbon groups bonded to the central sulfur atom. Depending upon the type of groups present, sulfides can be symmetrical or asymmetrical. Symmetrical sulfides can be prepared via an SN2 reaction between 2 equivalents of an alkyl halide and one equivalent of sodium sulfide.
5.0K