Rotator cuff repair with an interposition polypropylene mesh: A biomechanical ovine study

Chronic large to massive rotator cuff tears are difficult to treat and re-tears are common even after surgical repair. We propose using a synthetic polypropylene mesh to increase the tensile strength of rotator cuff repairs. We hypothesize that using a polypropylene mesh to bridge the repair of large rotator cuff tears will increase the ultimate failure load of the repair.

To investigate the mechanical properties of rotator cuff tears repaired with a polypropylene interposition graft in an ovine ex-vivo model.

A 20 mm length of infraspinatus tendon was resected from fifteen fresh sheep shoulders to simulate a large tear. We used a polypropylene mesh as an interposition graft between the ends of the tendon for repair. In seven specimens, the mesh was secured to remnant tendon by continuous stitching while mattress stitches were used for eight specimens. Five specimens with an intact tendon were tested. The specimens underwent cyclic loading to determine the ultimate failure load and gap formation.

The mean gap formation after 3000 cycles was 1.67 mm in the continuous group, and 4.16 mm in the mattress group (P = 0.001). The mean ultimate failure load was significantly higher at 549.2 N in the continuous group, 426.4 N in the mattress group and 370 N in the intact group (P = 0.003).

The use of a polypropylene mesh is biomechanically suitable as an interposition graft for large irreparable rotator cuff tears.