Related Experiment Video
Updated: Jul 26, 2025

Assessing Cerebral Autoregulation via Oscillatory Lower Body Negative Pressure and Projection Pursuit Regression
Published on: December 10, 2014
Force sensor reduced measurement error compared with verbal command during sit-to-stand assessment of cerebral
Alicen A Whitaker1,2,3, Eric D Vidoni4,5, Robert N Montgomery6
1Department of Physical Therapy, Rehabilitation Science, and Athletic Training, University of Kansas Medical Center, Kansas City, Kansas, USA.
Abstract:
Current methods estimate the time delay (TD) before the onset of dynamic cerebral autoregulation (dCA) from verbal command to stand. A force sensor used during a sit-to-stand dCA measure provides an objective moment an individual stands (arise-and-off, AO). We hypothesized that the detection of AO would improve the accuracy of TD compared with estimation. We measured middle cerebral artery blood velocity (MCAv) and mean arterial pressure (MAP) for 60 s sitting followed by 2-min standing, three times separated by 20 min. TD was calculated as the time from: (1) verbal command and (2) AO, until an increase in cerebrovascular conductance index (CVCi = MCAv/MAP). Sixty-five participants were enrolled: young adults (n = 25), older adults (n = 20), and individuals post-stroke (n = 20). The TD calculated from AO ( = 2.98 ± 1.64 s) was shorter than TD estimated from verbal command ( = 3.35 ± 1.72 s, η2 = 0.49, p < 0.001), improving measurement error by ~17%. TD measurement error was not related to age or stroke. Therefore, the force sensor provided an objective method to improve the calculation of TD compared with current methods. Our data support using a force sensor during sit-to-stand dCA measures in adults across the lifespan and post-stroke.
More Related Videos
11:06A Human-machine-interface Integrating Low-cost Sensors with a Neuromuscular Electrical Stimulation System for Post-stroke Balance Rehabilitation
Published on: April 12, 2016
14:09Tilt Testing with Combined Lower Body Negative Pressure: a "Gold Standard" for Measuring Orthostatic Tolerance
Published on: March 21, 2013
Related Concept Videos
Special considerations while measuring blood pressure
Monitoring Both Arms:
Monitoring BP in both arms during the initial assessment is advisable, as the systolic value may differ by five to ten mm Hg between arms. For subsequent BP assessments, use the arm with the higher reading.
Measurement of Blood Pressure