Correlation between the Humidity-Dependent Surface Microstructure and Macroconductivity of Anion Exchange Membranes

Anion exchange membrane (AEM) fuel cells have gained significant interest in recent years due to their promising applications in cost-effective and environmentally friendly energy conversion. Among various factors that affect their performance, water content plays an important role in the conductivity and stability of AEMs. However, the effect of the hydration level on the microstructure of AEMs and the correlation between the microstructure and macroconductivity have not been systematically investigated. In this work, four AEMs, quaternary ammonia polysulfone, quaternary ammonia poly(N-methyl-piperidine-co-p-terphenyl) (QAPPT), and bromoalkyl-tethered poly(biphenyl alkylene)s PBPA and PBPA-co-BPP, have been studied by atomic force microscopy and electrochemical impedance spectroscopy to elucidate the correlation between the humidity-dependent surface microstructure and macroconductivity of the AEMs. We obtained phase images by atomic force microscopy and identified hydrophilic and hydrophobic domains by fitting the distribution curve of phase images, which reasonably distinguishes hydrophilic domains from hydrophobic domains of the membrane surface, and thus, the surface hydrophilic area ratio and average size could be quantitatively analyzed. The conductivities of the membranes were then measured by electrochemical impedance spectroscopy at various humidities. The joint results from atomic force microscopy and electrochemical measurements help clarify the effect of the hydration level on the microphase separation and ionic conduction of the membranes.