Related Experiment Video
Updated: Jul 26, 2025

Transmission of Multiple Signals through an Optical Fiber Using Wavefront Shaping
Published on: March 20, 2017
Dynamic analysis of PAM-4 IM/DD OAM-based MGDM transmission enabled by mode-group filter approach
Abstract:
Mode-group-division multiplexing (MGDM)-based intensity modulation direct detection (IM/DD) transmission is an attractive approach to increase the capacity for short-reach optical communication. In this Letter, a simple but versatile scheme of mode group (MG) filtering for MGDM IM/DD transmission is proposed. The scheme is applicable to any mode basis in the fiber, and it satisfies the needs of low complexity, low power consumption, and high system performance. By employing the proposed MG filter scheme, a total raw bit rate of a 152-Gb/s multiple-input-multiple-output (MIMO)-free IM/DD co-channel simultaneous transmit and receive system based on two orbital angular momentum (OAM) MGs, each carrying a 38-GBaud four-level pulse amplitude modulation (PAM-4) signal, is experimentally demonstrated over a 5-km few-mode fiber (FMF). The bit error ratios (BERs) of the two MGs are below the 7% hard-decision forward error correction (HD-FEC) BER threshold at 3.8×10-3, using simple feedforward equalization (FFE). Furthermore, the dependability and robustness of such MGDM links are of great significance. Thus, the dynamic evaluation of BER and signal-to-noise ratio (SNR) for each MG is tested over 210 minutes under different conditions. In the dynamic cases, all the BER results using the proposed scheme can be below 1×10-3, which further confirms the stability and feasibility of our proposed MGDM transmission scheme.
Related Concept Videos
Frequency-Domain Interpretation of PD Control
The proportional control gain, combined with the...
Time-Domain Interpretation of PD Control
Consider the example of control of motor torque. Initially, a positive...
Transmission-Line Differential Equations
Line Section Model
A circuit representing a line section of length Δx helps in understanding the transmission line parameters. The voltage V(x) and current i(x) are measured...
Multimachine Stability
In analyzing the system, the nodal equations represent the relationship between bus voltages, machine voltages, and machine currents. The nodal equation is given by:
Transmission Line Design Considerations
IP3/DAG Signaling Pathway

