Related Experiment Video
Updated: Jul 26, 2025
In Situ Visualization of the Phase Behavior of Oil Samples Under Refinery Process Conditions
Published on: February 21, 2017
Temperature-dependent particle number emission rates and emission characteristics during heating processes of edible
Shengyuan Ma1, Yanshu Miao1, Wei Liu2
1School of Architecture, Harbin Institute of Technology, Key Laboratory of Cold Region Urban and Rural Human Settlement Environment Science and Technology, Ministry of Industry and Information Technology, Harbin, 150090, China.
Abstract:
The goal of this research is to investigate the temperature-dependent emission rates of particle numbers and emission characteristics during oil heating. Seven regularly used edible oils were studied in a variety of tests to attain this objective. First, total particle number emission rates ranging from 10 nm to 1 μm were measured, followed by an examination within six size intervals from 0.3 μm to 10 μm. Following that, the impacts of oil volume and oil surface area on the emission rate were investigated, and multiple regression models were developed based on the results. The results showed that corn, sunflower and soybean oils had higher emission rates than other oils above 200 °C, with peak values of 8.22 × 109#/s, 8.19 × 109#/s and 8.17 × 109#/s, respectively. Additionally, peanut and rice oils were observed to emit the most particles larger than 0.3 μm, followed by medium-emission (rapeseed and olive oils) and low-emission oils (corn, sunflower and soybean oils). In most cases, oil temperature (T) has the most significant influence on the emission rate during the smoking stage, but its influence was not as pronounced in the moderate smoking stage. The models obtained are all statistically significant (P < 0.001), with R2 values greater than 0.9, and the classical assumption test concluded that regressions were in accordance with the classical assumptions regarding normality, multicollinearity, and heteroscedasticity. In general, low oil volume and large oil surface area were more recommended for cooking to mitigate UFPs emission.
More Related Videos
Related Concept Videos
01:27Atomic Spectroscopy: Effects of Temperature
At thermal equilibrium, the relative populations of excited and ground state atoms can be estimated using the Maxwell–Boltzmann distribution. For example, an increase in temperature...
02:28Effect of Temperature Change on Reaction Rate
02:19Le Chatelier's Principle: Changing Temperature
To understand this phenomenon, consider the elementary reaction:
02:55Temperature Dependence on Reaction Rate
Atoms, molecules, or ions must collide before they can react with each other. Atoms must be close together to form chemical bonds. This premise is the basis for a theory that explains many observations regarding chemical kinetics, including factors affecting reaction rates.
The collision theory is based on the postulates that (i) the reaction rate is proportional to the rate of reactant collisions, (ii) the reacting species collide in an orientation allowing contact between...
02:46Quantifying Heat
02:44Heating and Cooling Curves
For instance, the addition of heat raises the temperature of a solid; the amount of heat absorbed depends on the heat capacity of the solid (q = mcsolidΔT). According to thermochemistry, the relation between the amount of heat absorbed or released by a substance, q, and its...