Exploring HONO formation and its role in driving secondary pollutants formation during winter in the North China

Shaobin Zhang1, Guo Li2, Nan Ma1

  • 1Institute for Environmental and Climate Research, Jinan University, Guangzhou 511443, China; Guangdong-Hongkong-Macau Joint Laboratory of Collaborative Innovation for Environmental Quality, Guangzhou 511443, China.

Related Concept Videos

Standard Enthalpy of Formation02:37

Standard Enthalpy of Formation

Enthalpy changes are typically tabulated for reactions in which both the reactants and products are at the same conditions. A standard state is a commonly accepted set of conditions used as a reference point for the determination of properties under other different conditions. For chemists, the IUPAC standard state refers to materials under a pressure of 1 bar and solutions at 1 M and does not specify a temperature. Many thermochemical tables list values with a standard state of 1 atm. Because...
42.0K
Aldehydes and Ketones with HCN: Cyanohydrin Formation Overview01:32

Aldehydes and Ketones with HCN: Cyanohydrin Formation Overview

Cyanohydrins are compounds that contain –CN and –OH groups on the same carbon atom. They are formed by the nucleophilic addition of the cyanide ions to the carbonyl group. Cyanide ions are highly basic and nucleophilic and can be generated from HCN under aqueous conditions. However, since HCN is a weak acid, the number of cyanide ions generated is very small. Hence, a small amount of base or KCN/NaCN is added to HCN to increase the concentration of the cyanide ions in the reaction...
2.9K
Aldehydes and Ketones with HCN: Cyanohydrin Formation Mechanism01:10

Aldehydes and Ketones with HCN: Cyanohydrin Formation Mechanism

Cyanohydrins are formed when cyanide nucleophiles and carbonyl compounds like aldehydes and ketones react. A strong base, the cyanide ion, catalyzes cyanohydrin formation. The ions are generated from HCN under aqueous conditions. Once the cyanide ions are generated, the first step involves the nucleophilic attack of the cyanide ions on the electrophilic carbonyl carbon. This attack shifts the π electrons from the C=O to the oxygen atom forming the alkoxide ion intermediate. The alkoxide anion...
3.3K
Washing, Drying, and Ignition of Precipitates00:52

Washing, Drying, and Ignition of Precipitates

After filtration, the precipitate is washed to remove coprecipitated impurities and any remaining mother liquor. Colloidal precipitates, such as silver chloride, are washed with an electrolyte (such as dilute nitric acid) to prevent the peptization of the precipitate. In the case of slightly soluble precipitates, the wash solution contains a common ion to reduce solubility. Lead sulfate, which is slightly soluble in water, is washed with dilute sulfuric acid. Similarly, wash solutions may be...
977
Precipitation Processes01:12

Precipitation Processes

The experimental conditions in a gravimetric analysis should be optimized to maximize the particle size and purity of the obtained precipitate. Ideally, the concentration of the precipitating reagent should be low with effective stirring to maintain low relative supersaturation for the growth of large crystals. In homogeneous precipitation, the precipitant is slowly generated by a chemical reaction in the solution to avoid local reagent excesses. For example, urea decomposes gradually to...
495
Regioselective Formation of Enolates01:33

Regioselective Formation of Enolates

As depicted in the figure below, the unsymmetrical ketones can form two possible enolates:  less substituted or more substituted enolates. Usually, the thermodynamic enolates are formed from the more substituted α-carbon atom, while the kinetic enolates are formed faster by deprotonation from the less substituted position. The thermodynamic enolates have lower energy, so they are  more stable. But the energy required to form kinetic enolates is less.
2.7K