Optimal aeration area of cathode electrode in the batch type of microbial fuel cells with non-woven interface

Microbial fuel cells (MFCs) are based on the biochemical reaction of microorganisms to decompose organic wastewater for converting chemical energy into power energy. MFCs are considered an environmentally friendly technology that is gaining popularity due to their simultaneous digestion and energy production abilities. To enhance its real application in wastewater treatment, this study proposes to use a non-woven material for replacing the usage of expensive membranes in MFCs. In addition, the study aims to consider a series of different aeration areas of cathode electrodes for finding an optional design. Results have shown that the adoption of non-woven with 0.45 μm can effectively prohibit the diffusion of oxygen into the anode chamber. Moreover, the non-woven material played an important role as an interface between the anode and cathode, enhancing the MFC performance. The usage of suitable non-woven material can replace the role of the membrane when applied in real wastewater applications. The results have shown that the case study where a combination of a 50% aeration area of the cathode electrodes with 25% exposure of the cathode plate in the air yielded relatively better aeration in terms of a higher current density of 250 mA/m², higher power density of 220 mW/m², and higher open voltage circuit of 0.4 V, compared to other case studies considered. These results indicate the optimal aeration configuration for MFCs applied in commercial wastewater treatment in the future.