Related Experiment Video
Updated: Jul 26, 2025

Measuring Carbon-based Contaminant Mineralization Using Combined CO2 Flux and Radiocarbon Analyses
Published on: October 21, 2016
Engineering-geological comparative analysis of four cases studies of waste landfills
Marian Marschalko1, Dariusz Popielarczyk2, Petr Vicherek1
1Department of Geological Engineering, Faculty of Mining and Geology, VSB-Technical University of Ostrava, 17 listopadu 15, 708 33, Ostrava, Czech Republic.
Abstract:
The aim of the paper is to carry out a comparative engineering-geological study of four different waste landfills using the evaluation criteria for the geological subsoil as a natural sealing barrier. The study evaluates 4 localities (Velké Pavlovice, Kvítkovice, Prakšice and Horní Suchá) using three variants (based on two standards) which approach the geological barrier requirements as a combination of impermeability requirements based on a filtration coefficient limit value. and the required geometry represented by investigation depths. The research was carried out in landfills in Moravia, in the east of the Czech Republic. The study's motivation is to point at the differences in engineering-geological investigations of waste landfills (as for the requirements for impermeable geological subsoil as a natural sealing barrier) when compared with other engineering structures (where the main goal is to evaluate load-bearing capacity and settlement). The purpose of the geological barrier is to prevent the spread of contamination, and the paper shows this can be approached differently, as shown in two different methodologies investigated herein. The first model (Model 1) assumes there is a 3-m-thick subsoil below the landfill's footing bottom, which manifests impermeability characterized by the filtration coefficient Kf ≤ 1.0 * 10-9 m/s, or a 30-m-thick subsoil of Kf ≤ 1.0 * 10-8 m/s. The second model (Model 2) assumes a 1-m thick, impermeable subsoil massif of Kf ≤ 1.0 * 10-9 m/s. We found that none of the landfills in the four selected localities had an impermeable layer in the required depth (a filtration coefficient Kf from 1.8 * 10-9 to 3.9 * 10-9 m/s), and thus did not comply with the limiting conditions. As a result, an anthropogenic technical barrier had to be installed. An important goal of the study from an environmental point of view was to assess the existence of a suitable geological barrier under the proposed landfills. The most important criterion from this point of view is permeability. An additional technical objective of the project was also the assessment of the possible creation of a technical anthropogenic isolation barrier. In the event that the natural sealing barrier would not be sufficient. This was shown in all solved case studies of engineering geological investigations of waste landfills.
Related Concept Videos
Manipulation and Analysis
Design Example: Alignment of a Road Line Using GIS
Design Example: Analyzing Capacity Contours for Flood Risk Assessment
Design Example: Aggregate Gradation
The grading, or particle-size distribution, of sand is determined using sieve analysis, with standard sizes ranging from 150 μm to 10 mm (ASTM No. 100 sieve to 3⁄8 in. sieve). Sand is...
Design Example: Maintaining Level of an Embankment

