Related Experiment Video
Updated: Jul 26, 2025

Solid-state Graft Copolymer Electrolytes for Lithium Battery Applications
Published on: August 12, 2013
Highly stable lithium sulfur batteries enhanced by flocculation and solidification of soluble polysulfides in routine
Rui Xu1, Jiashuo Shao1, Keke Gao1
1School of Materials Science and Engineering, Zhengzhou University, Kexue Ave 100, Zhengzhou 450001, China.
Abstract:
Lithium-sulfur batteries (LSBs) are among the most promising next-generation high energy density energy-storage systems. However, practical application has been hindered by fundamental problems, especially shuttling by the higher-order polysulfides (PSs) and slow redox kinetics. Herein, a novel electrolyte-based strategy is proposed by adding an ultrasmall amount of the low-cost and commercially available cationic antistatic agent octadecyl dimethyl hydroxyethyl quaternary ammonium nitrate (SN) into a routine ether electrolyte. Due to the strong cation-anion interaction and bridge-bonding with SN, rapid flocculation of the soluble polysulfide intermediates into solid-state polysulfide-SN sediments is found, which significantly inhibited the adverse shuttling effect. Moreover, a catalytic effect was also demonstrated for conversion of the polysulfide-SN intermediates, which enhanced the redox kinetics of Li-S batteries. Encouragingly, for cells with only 0.1 % added SN, an initial specific capacity of 783.6 mAh/g and a retained specific capacity of 565.7 mAh/g were found at 2C after 200 cycles, which corresponded to an ultralow capacity decay rate of only 0.014 % per cycle. This work may provide a simple and promising regulation strategy for preparing highly stable Li-S batteries.
More Related Videos
Related Concept Videos
Formation of Complex Ions
Colloidal precipitates
Precipitation and Co-precipitation
Preparation and Reactions of Sulfides
Coagulation
Electrophilic Aromatic Substitution: Sulfonation of Benzene

