Hofstadter Topology with Real Space Invariants and Reentrant Projective Symmetries

Jonah Herzog-Arbeitman1, Zhi-Da Song1,2, Luis Elcoro3

  • 1Department of Physics, Princeton University, Princeton, New Jersey 08544, USA.

PubMed

Related Concept Videos

Gauss's Law: Planar Symmetry01:27

Gauss's Law: Planar Symmetry

A planar symmetry of charge density is obtained when charges are uniformly spread over a large flat surface. In planar symmetry, all points in a plane parallel to the plane of charge are identical with respect to the charges. Suppose the plane of the charge distribution is the xy-plane, and the electric field at a space point P with coordinates (x, y, z) is to be determined. Since the charge density is the same at all (x, y) - coordinates in the z = 0 plane, by symmetry, the electric field at P...
8.0K
Space-Time Curvature and the General Theory of Relativity01:17

Space-Time Curvature and the General Theory of Relativity

In 1905, Albert Einstein published his special theory of relativity. According to this theory, no matter in the universe can attain a speed greater than the speed of light in a vacuum, which thus serves as the speed limit of the universe.
This has been verified in many experiments. However, space and time are no longer absolute. Two observers moving relative to one another do not agree on the length of objects or the passage of time. The mechanics of objects based on Newton's laws of...
2.8K
Plastic Deformations of Members with a Single Plane of Symmetry01:21

Plastic Deformations of Members with a Single Plane of Symmetry

When a structural member undergoes plastic deformation due to bending, it is crucial to understand the position of the neutral axis and the stress distribution. This member, characterized by a single plane of symmetry, exhibits a uniform stress distribution, with negative stress above the neutral axis and positive stress below. Notably, the neutral axis does not align with the centroid of the cross-section. This misalignment is typical in cases where the cross-section is not rectangular or...
111
Parallel-axis Theorem01:06

Parallel-axis Theorem

The parallel-axis theorem provides a convenient and quick method of finding the moment of inertia of an object about an axis parallel to the axis passing through its center of mass. Consider a thin rod as an example. There is a striking similarity between the process of finding the moment of inertia of a thin rod about an axis through its middle, where the center of mass lies, and about an axis through its end using the conventional method. In the conventional method, the concept of linear mass...
7.0K
Castigliano's Theorem01:18

Castigliano's Theorem

Castigliano's theorem analyzes displacements and rotations in elastic structures. It relates the derivative of elastic strain energy to the applied forces or moments, allowing for the calculation of deformations. The theorem states that the partial derivative of the total strain energy of a system with respect to a specific load results in the displacement at the point where the load is applied. This principle applies to both forces and moments.
445
Woodward–Hoffmann Selection Rules and Microscopic Reversibility01:34

Woodward–Hoffmann Selection Rules and Microscopic Reversibility

Electrocyclic reactions, cycloadditions, and sigmatropic rearrangements are concerted pericyclic reactions that proceed via a cyclic transition state. These reactions are stereospecific and regioselective. The stereochemistry of the products depends on the symmetry characteristics of the interacting orbitals and the reaction conditions. Accordingly, pericyclic reactions are classified as either symmetry-allowed or symmetry-forbidden. Woodward and Hoffmann presented the selection criteria for...
3.2K