Impact of different anode materials on electro-Fenton process and tannery wastewater treatment using sequential...

The influence of anode materials on the electrochemical treatment of tannery wastewater (TWW) was evaluated using Pt, Ti/RuO₂-IrO₂ (DSA), Ti/SnO₂-Sb, Ti/PbO₂, and Ti/SnO₂-Sb/PbO₂ electrodes. The comparison of the degradation mechanism of these electrodes in the electro-Fenton (EF) treatment was evaluated. The Ti/SnO₂-Sb/PbO₂ anode was efficient, with high electrocatalytic activity, stability, and reproducibility of the degradation results. Further, the study was extended to define the ability of sequential EF and electrocoagulation (EC) processes to clean TWW. The EC treatment was conducted using Al electrodes, and the performance of the combined treatment was evaluated by the removal of chemical oxygen demand (COD), turbidity, total suspended solids (TSS), sulfide, and Cr removal. The role of chlorides and sulfate salts during both treatments was evaluated by monitoring the concentration changes of these anions during the whole treatment using ion chromatography (IC). A sequential 1.5 h EF and 1 h EC treatment were applied to achieve a satisfactory degradation of (81.2 ± 3.9)% COD, >98% Cr, >99% turbidity, TSS, and sulfide removal. Additionally, the combined treatment was found to be more efficient towards the COD removal, achieving about 22.5% higher COD removal consuming almost the same amount of electrical energy.