An Experimental and Simulation Study of the Active Camber Morphing Concept on Airfoils Using Bio-Inspired Structures

Birds are capable of morphing their wings across different flight modes and speeds to improve their aerodynamic performance. In light of this, the study aims to investigate a more optimized solution compared to conventional structural wing designs. The design challenges faced by the aviation industry today require innovative techniques to improve flight efficiency and minimize environmental impact. This study focuses on the aeroelastic impact validation of wing trailing edge morphing, which undergoes significant structural changes to enhance performance as per mission requirements. The approach to design-concept, modeling, and construction described in this study is generalizable and requires lightweight and actively deformable structures. The objective of this work is to demonstrate the aerodynamic efficiency of an innovative structural design and trailing edge morphing concept compared to conventional wing-flap configurations. The analysis revealed that the maximum displacement at a 30-degree deflection is 47.45 mm, while the maximum stress is 21 MPa. Considering that the yield strength of ABS material is 41.14 MPa, this kerf morphing structure, with a safety factor of 2.5, can withstand both structural and aerodynamic loads. The analysis results of the flap and morph configurations showed a 27% efficiency improvement, which was confirmed through the convergence criteria in ANSYS CFX.