Related Experiment Video
Updated: Jul 24, 2025

Measurements of Local Instantaneous Convective Heat Transfer in a Pipe - Single and Two-phase Flow
Published on: April 30, 2018
Mathematical analysis of mixed convective stagnation point flow over extendable porous riga plate with aggregation
Hakeem A Otman1, Zafar Mahmood2, Umar Khan2
1Department of Mathematics, AL-Qunfudhah University College, Umm Al-Qura University, Saudi Arabia.
Abstract:
It is still not quite apparent how suspended nanoparticles improve heat transmission. Multiple investigations have demonstrated that the aggregation of nanoparticles is a critical step in improving the thermal conductivity of nanofluids. However, the thermal conductivity of the nanofluid would be greatly affected by the fractal dimension of the nanoparticle aggregation. The purpose of this research is to learn how nanoparticle aggregation, joule heating, and a heat source affect the behavior of an ethylene glycol-based nanofluid as it flows over a permeable, heated, stretched vertical Riga plate and through a porous medium. Numerical solutions to the present mathematical model were obtained using Mathematica's Runge-Kutta (RK-IV) with shooting technique. In the stagnation point flow next to a permeable, heated, extending Riga plate, heat transfer processes and interrupted flow phenomena are defined and illustrated by diagrams in the proposed mixed convection, joule heating, and suction variables along a boundary surface. Data visualizations showed how different variables affected temperature and velocity distributions, skin friction coefficient, and the local Nusselt number. The rates of heat transmission and skin friction increased when the values of the suction parameters were raised. The temperature profile and the Nusselt number both rose because of the heat source setting. The increase in skin friction caused by changing the nanoparticle volume fraction from to for the without aggregation model was about 7.2% for the case of opposing flow area and 7.5% for the case of aiding flow region . With the aggregation model, the heat transfer rate decreases by approximately 3.6% for cases with opposing flow regions and 3.7% for cases with assisting flow regions , depending on the nanoparticle volume fraction and ranging from to , respectively. Recent findings were validated by comparing them to previously published findings for the same setting. There was substantial agreement between the two sets finding.
More Related Videos
10:23Author Spotlight: Computing the Effects of a Local Radiofrequency Hyperthermia Intervention on Tumor Biomechanics
Published on: December 1, 2023
10:03Uncoupling Coriolis Force and Rotating Buoyancy Effects on Full-Field Heat Transfer Properties of a Rotating Channel
Published on: October 5, 2018
Related Concept Videos
Steady, Laminar Flow Between Parallel Plates
Couette Flow
Fluid Pressure over Curved Plate of Constant Width
Steady, Laminar Flow in Circular Tubes
Fluid Pressure over Flat Plate of Variable Width
The pressure distribution on the plate can be calculated by determining the force that acts on a differential area strip of the plate. Thus, the magnitude of the force is equal to the...
Fluid Pressure over Flat Plate of Constant Width
The resultant force...