Experimental study on flow and turbulence characteristics of jet impinging on cylinder using three-dimensional...

When a round jet impinges on a convex cylindrical surface, complex three-dimensional (3D) flow structures occur, accompanied by the Coanda effect. To characterize the flow and turbulence properties of the general system, ensemble averages of 3D Lagrangian particle tracking velocimetry measurements were taken. The radial bin-averaging method was used in post-processing the tracked particles and corresponding instantaneous velocity vectors to generate appropriate ensemble-averaged statistics. Two impinging angles were selected, and at a fixed Reynolds number, the ensemble-averaged volumetric velocity field and turbulent stress tensor components were measured. The flow and turbulence characteristics of the impinging jet on the cylinder were notably different based on the impinging angle, especially in the downstream region. Surprisingly, the attached wall jet with a half-elliptic shape was abruptly thickened in the wall-normal direction, similar to the axis switching phenomenon observed in elliptic jets in the case of oblique impingement. In the jet-impinging region, the flow spread in all directions with high mean vorticity values. With the development of a 3D curved wall jet, both the Coanda effect and centrifugal force played a significant role in the flow behavior. A notable feature of the self-preserving region was the similarity of mean velocity profiles with scaling by the maximum velocity and the jet half-width for both impinging angle cases. Local isotropy of turbulent normal stresses was observed in this region, supporting the existence of self-preservation in the 3D curved wall jet. The volumetric ensemble-averaged Reynolds stress tensor revealed strong inhomogeneous turbulence in the boundary layer region and the curvature effect on the Reynolds shear stress in the free shear layer.