Effect of toe-out gait modification on patellofemoral joint loading

Toe-out gait has been proposed as a conservative treatment to reduce medial tibiofemoral joint loading. However, patellofemoral joint loading during toe-out gait is not yet understood.

Does the toe-out gait modification affect patellofemoral joint loading?

Sixteen healthy adults were enrolled in this study. The natural gait and toe-out gait were measured using a three-dimensional motion analysis and a force plate. The knee flexion angle and external knee flexion moment during the stance phase were calculated. Thus, dynamic knee joint stiffness, a proxy of patellofemoral joint loading, was defined as a linear regression of the knee flexion moment and knee flexion angle during the early stance. Additionally, the peak patellofemoral compressive force during the early stance was calculated using a musculoskeletal simulation. A paired t-test was used to compare these biomechanical parameters during the natural gait and toe-out gait.

The toe-out gait significantly increased the peak patellofemoral compressive force (mean difference = 0.37 BW, P = 0.017) and dynamic knee joint stiffness (mean difference = 0.07%BW*Ht/°, P = 0.001). The 1st peak of the knee flexion moment also significantly increased in the toe-out gait (mean difference = 1.01%BW*Ht, P = 0.003); however, the knee flexion angle did not change significantly (initial contact: mean difference = 1.7°, P = 0.078; peak: mean difference = 1.3°, P = 0.224).

Toe-out gait increased the patellofemoral compressive force and dynamic knee joint stiffness because of increasing knee flexion moment, but not the knee flexion angle. When the toe-out gait is adapted, clinicians should pay attention to an increase in the patellofemoral joint loading.