Related Experiment Video
Updated: Jul 24, 2025
A Step by Step Protocol for Subretinal Surgery in Rabbits
Published on: September 13, 2016
Prestrain in the eardrum investigated using laser-ablation perforation: A proof of principle study on the New Zealand
Pieter Livens1, Joris J J Dirckx2
1University of Antwerp, Antwerp 2020, Belgium; Laboratory of Biomedical Physics (BIMEF), University of Antwerp, Groenenborgerlaan 171, Antwerp 2020, Belgium.
Abstract:
While the presence of residual stress (also called prestress) in the tympanic membrane (TM) was hypothesized more than 150 years ago by von Helmholtz (1869), little experimental data exists to date. In this paper, a novel approach to study residual stress is presented. Using a pulsed laser, the New Zealand white rabbit TM is perforated at seven predefined locations. The subsequent retraction of the membrane around the holes is computed using digital image correlation (DIC). The amount of retraction is the so-called prestrain, which is caused by the release of prestress due to the perforation. By measuring the prestrain using DIC, we show that residual stress is clearly present over the entire rabbit TM surface. In total, fourteen TMs have been measured in this work. An automated approach allows tracking the holes' deformation during the measurement process and enables a more robust analysis than was previously possible. We find similar strains (around 5%) as reported in previous work, in which slits were created manually using flattened surgical needles. However, the new approach greatly reduces measurement time, which minimizes dehydration artifacts. To investigate the effect of perforation location on the TM, the spatial decrease of the prestrain (α) around the perforation was quantified. Perforations inferior to the umbo showed the least negative α values, i.e., the most gradual decrease around the hole, and were the most consistent. Perforations on other locations showed more negative α values, i.e., steeper decrease in strain, but were less consistent across samples. We also investigated the effect of the holes' creation sequence but did not observe a significant change in the results. Overall, the presented method allows for consistent residual stress measurements over the TM surface. The findings contribute to our fundamental knowledge of the mechanics of the rabbit TM and provide a basis for future work on human TMs.
