Exact exchange with range-separated algorithm for thermodynamic limit of periodic Hartree-Fock theory

Qiming Sun1

  • 1Quantum Engine LLC, Lacey, Washington 98516, USA.

PubMed

Related Concept Videos

The Pauli Exclusion Principle03:06

The Pauli Exclusion Principle

The arrangement of electrons in the orbitals of an atom is called its electron configuration. We describe an electron configuration with a symbol that contains three pieces of information:
39.8K
Hess's Law03:40

Hess's Law

There are two ways to determine the amount of heat involved in a chemical change: measure it experimentally, or calculate it from other experimentally determined enthalpy changes. Some reactions are difficult, if not impossible, to investigate and make accurate measurements for experimentally. And even when a reaction is not hard to perform or measure, it is convenient to be able to determine the heat involved in a reaction without having to perform an experiment.
45.2K
The Small x Assumption02:20

The Small x Assumption

If a reaction has a small equilibrium constant, the equilibrium position favors the reactants. In such reactions, a negligible change in concentration may occur if the initial concentrations of reactants are high and the Kc value is small. In such circumstances, the equilibrium concentration is approximately equal to its initial concentration.  This estimation can be used to simplify the equilibrium calculations by assuming that some equilibrium concentrations are equal to the initial...
46.2K
Equilibrium Conditions for a Particle01:23

Equilibrium Conditions for a Particle

When an object is in equilibrium, it is either at rest or moving with a constant velocity. There are two types of equilibrium: static and dynamic. Static equilibrium occurs when an object is at rest, while dynamic equilibrium occurs when an object is moving with a constant velocity. In both cases, there must be a balance of forces acting on the object.
To understand the concept of equilibrium, let us first consider the forces acting on an object. When different forces act on an object, they can...
1.2K
Real Gases: Effects of Intermolecular Forces and Molecular Volume Deriving Van der Waals Equation04:01

Real Gases: Effects of Intermolecular Forces and Molecular Volume Deriving Van der Waals Equation

Thus far, the ideal gas law, PV = nRT, has been applied to a variety of different types of problems, ranging from reaction stoichiometry and empirical and molecular formula problems to determining the density and molar mass of a gas. However, the behavior of a gas is often non-ideal, meaning that the observed relationships between its pressure, volume, and temperature are not accurately described by the gas laws. 
34.7K
Thermodynamic Potentials01:26

Thermodynamic Potentials

Thermodynamic potentials are state functions that are extremely useful in analyzing a thermodynamic system. They have dimensions of energy. The four important thermodynamic potentials are internal energy, enthalpy, Helmholtz free energy, and Gibbs free energy. These thermodynamic potentials can be expressed using two of the following variables: pressure, volume, temperature, and entropy. These two variables are expressed as the rate of change of the thermodynamic potential with respect to other...
879