Biomass-derived carbon deposited TiO₂ nanotube photocatalysts for enhanced hydrogen production

In this study, titanium oxide nanotubes (TiO₂NTs) were deposited on the surface of activated carbon (AC) by varying the wt% of AC. The physicochemical properties of synthesized TiO₂NTs-AC nanocomposites were analysed by various characterization techniques such as XRD, FT-IR, Raman, DRUV-vis, HR-TEM, XPS, PL, and N₂ physisorption. The FT-IR, EDX, and XPS analyses proved the existence of interaction between AC and TiO₂NTs. This study found that as the content of AC increases, the surface area and pore volume increase while the energy bandgap decreases. The TiO₂NTs-AC nanocomposite with 40% AC exhibited a surface area of 291 m² g^-1, pore volume of 0.045 cm³ g^-1 and half pore width = 8.4 Å and had a wide band gap energy (3.15 eV). In addition, the photocatalytic application of the prepared nanocomposites for photocatalytic H₂ production was investigated. The H₂ was produced via photo-reforming in the presence of a sacrificial agent (methanol) under sunlight irradiation. It was found that the prepared TiO₂NTs-AC nanocomposite with 40% AC acted as an efficient photocatalyst for aqueous-methanol reforming under various optimization conditions. Approximately 18 000 μmol^-1 hydrogen gas was produced via aqueous-methanol reforming under optimized conditions (catalyst dose = 100 mg, temperature = 25 °C, time = 12 hours, vol. of methanol = 20% (v/v), and pH = 7). The reusability of the TiO₂NTs-AC nanocomposite was also investigated for 5 consecutive cycles, and the results suggested only a slight decline in efficiency even after the fifth cycle. This study demonstrates the ability of an activated carbon deposited TiO₂NT catalyst to produce hydrogen effectively under sunlight.