Related Experiment Video
Updated: Jul 23, 2025

Quantification of Orofacial Phenotypes in Xenopus
Published on: November 6, 2014
Classification of Skeletal Phenotypes of Adult Patients With Cleft Skeletal Class III Malocclusion Using Principal
Il-Hyung Yang1, Haeddeuri Kim2, Jee Hyeok Chung3
1Department of Orthodontics, School of Dentistry, Seoul National University.
Abstract:
The purpose of this study was to classify the skeletal phenotypes of adult patients with skeletal class III (C-III) malocclusion and unilateral or bilateral cleft lip and palate using principal component analysis and cluster analysis. The samples consisted of 81 adult C-III patients with cleft lip and palate (CLP) who underwent orthognathic surgery (OGS) or distraction osteogenesis (59 males and 22 females; 50 unilateral cleft lip and palate and 31 bilateral cleft lip and palate; mean age when lateral cephalograms were taken, 22.2±4.6 y). Thirteen angular and one ratio cephalometric variables were measured. Using 4 representative variables obtained from principal component analysis (SNA, SNB, Gonial angle, and Bjork sum), K-means cluster analysis was performed to classify the phenotypes. Then, statistical analysis was conducted to characterize the differences in the variables among the clusters. Five clusters were obtained from 3 groups: severely retrusive maxilla and moderately retrusive mandible group: cluster-1 (23.5%, severely hyperdivergent pattern), cluster-4 (27.2%, moderately hyperdivergent pattern), and cluster-5 (11.1%, normodivergent pattern); moderately retrusive maxilla and normal mandible group: cluster-2 (30.9%, normodivergent pattern); normal maxilla and moderately protrusive mandible group: cluster-3 (7.4%, normodivergent pattern). Although skeletal phenotypes were diverse, distribution of sex and cleft type did not differ among 5 clusters ( P >0.05). Sixty-two percent of cleft patients showed a severely retrusive maxilla and moderately retrusive mandible (cluster-1, cluster-4, and cluster-5), which indicated that these are the main cause of skeletal C-III malocclusion in CLP patients who were treated with OGS. Therefore, it is necessary to consider presurgical orthodontic treatment and surgical planning based on the skeletal phenotypes of CLP patients.
More Related Videos
Related Concept Videos
Classification of Bones
Long and Short Bones
The appendicular skeleton, particularly the upper and lower limbs, is primarily made of long and short bones. The...
Structural Classification of Joints
A fibrous joint is where the adjacent bones are united by fibrous connective...
Classification of Skeletal Muscle Fibers
Slow-Twitch Muscle Fibers
Slow oxidative, muscle fibers appear red due to large numbers of capillaries and high levels of...
Functional Classification of Joints
The functional classification of joints is determined by the amount of mobility between the adjacent bones. Joints are functionally classified as a synarthrosis or immobile joint, an amphiarthrosis or slightly moveable joint, or as a diarthrosis, a freely moveable joint. Fibrous and cartilaginous joints can be functionally classified as either synarthroses or amphiarthroses, whereas all synovial joints are classified as diarthroses.
Synarthrosis
An...
Sutures of the Skull
Sutures are immobile joints between adjacent bones of the skull. The narrow gap between the bones is filled with dense, fibrous connective tissue that unites the bones. The long sutures located between the skull bones are not straight but instead follow irregular, tightly twisting paths. These twisting lines tightly...
Assessment of Airway, Skin Color, and Use of Accessory Muscles
Introduction
The initial evaluation of a patient's respiratory system...

