Related Experiment Video
Updated: Jul 22, 2025
Hydrogen Production and Utilization in a Membrane Reactor
Published on: March 10, 2023
Design and operation performance of the plate-heat transfer type hydrogen production reactor for bio-methanol
Hong Liu1, Yameng Li1, Chaoyang Lu2
1Key Laboratory of New Materials and Facilities for Rural Renewable Energy (Ministry of Agriculture and Rural Affairs of China), Henan Agricultural University, Zhengzhou 450002, China; Institute of Agricultural Engineering, Huanghe S & T University, Zhengzhou 450006, China.
Abstract:
In this paper, the plate-heat transfer type bio-methanol steam reforming reactor for hydrogen fuel cell vehicles and its operation performance was studied. The structure of the plate-heat transfer type for bio-methanol reforming has been designed and optimized with the application parameters of hydrogen production capacity, hydrogen production rate, bio-methanol conversion rate, volume limitation. Results showed the catalyst particle size has little influence when it less than 0.85 mm; However, when the catalyst loading was 20 g and the feed rate of bio-methanol solution was 1.5 mL/min, the effect of reforming bio-methanol was the best. At this time, the specific hydrogen production was 64.062 mL/gcat.min, the hydrogen production rate was 21.354 mL/s, the bio-methanol conversion rate was 82.25%. This paper can provide scientific reference for further research and development of high-efficiency and low-cost bio-methanol reforming hydrogen production equipment.
More Related Videos
Related Concept Videos
02:13Reduction of Alkenes: Catalytic Hydrogenation
Metals like palladium, platinum, and nickel are commonly used in their solid forms — fine powder on an inert surface. As these catalysts remain insoluble in the reaction mixture, they are referred to as heterogeneous catalysts.
The hydrogenation process takes place on the...
02:17Reduction of Alkenes: Asymmetric Catalytic Hydrogenation
The metal catalyst used can be either heterogeneous or homogeneous. When hydrogenation of an alkene generates a chiral center, a pair of enantiomeric products is expected to form. However, an enantiomeric excess of one of the products can be facilitated using an enantioselective reaction or an...