Related Experiment Video

Updated: Aug 11, 2026

Reverse Total Shoulder Arthroplasty
10:10

Reverse Total Shoulder Arthroplasty

Published on: July 5, 2011

43.3K

Correlation Between Altmetric Scores and Citation Count in 4 High-Impact Plastic Surgery Journals

Taylor M Smartz, Sinan K Jabori, Mak B Djulbegovic

    Aesthetic Surgery Journal
    |July 20, 2023
    PubMed
    Abstract

    More Related Videos

    Comparing Bibliometric Analysis Using PubMed, Scopus, and Web of Science Databases05:02

    Comparing Bibliometric Analysis Using PubMed, Scopus, and Web of Science Databases

    Published on: October 24, 2019

    31.6K
    The Use of Mixed Reality in Custom-Made Revision Hip Arthroplasty: A First Case Report07:45

    The Use of Mixed Reality in Custom-Made Revision Hip Arthroplasty: A First Case Report

    Published on: August 4, 2022

    3.4K

    Related Concept Videos

    Chi-square Analysis02:46

    Chi-square Analysis

    The chi-square test is a statistical hypothesis test. It is used to check whether there is a significant difference between an expected value and an observed value. In the context of genetics, it enables us to either accept or reject a hypothesis, based on how much the observed values deviate from the expected values.
    The chi-square test was developed by Pearson in 1990.
    The first step of performing a Chi-square analysis is to establish a null hypothesis, which assumes that there is no real...
    Plastic Behavior01:21

    Plastic Behavior

    A material's elastic behavior is characterized by the disappearance of stress once the load is removed, allowing the material to return to its original state. However, when stress surpasses the yield point, yielding commences, marking the onset of plastic deformation or permanent set. This change from elastic to plastic behavior is influenced by the peak stress value and the duration before the load is removed. An intriguing observation occurs when a specimen is loaded, unloaded, and reloaded.
    Plastic Deformations01:14

    Plastic Deformations

    It is essential to understand how structural members behave under plastic deformation when the bending stress exceeds the material's yield strength. This state of deformation permanently alters the shape of the member, in contrast to the linear elastic behavior observed before yielding. The strain at any point in the member is expressed in terms of maximum strain. Notably, the neutral axis, which coincides with the centroid during elastic bending, shifts away from the centroid under plastic...
    Plastic Deformations of Members with a Single Plane of Symmetry01:21

    Plastic Deformations of Members with a Single Plane of Symmetry

    When a structural member undergoes plastic deformation due to bending, it is crucial to understand the position of the neutral axis and the stress distribution. This member, characterized by a single plane of symmetry, exhibits a uniform stress distribution, with negative stress above the neutral axis and positive stress below. Notably, the neutral axis does not align with the centroid of the cross-section. This misalignment is typical in cases where the cross-section is not rectangular or...
    Plastic Deformations01:19

    Plastic Deformations

    Plastic deformation represents a fundamental concept in materials science, which explains the irreversible change in the shape of a material when it experiences stress beyond its elastic capability. This phenomenon is important in structural engineering, especially in designing and analyzing cantilever beams—structures that are securely fixed at one end and bear loads at the opposite end. When these beams are subjected to loads within their elastic range, they will return to their original...