Injury severity of single-vehicle large-truck crashes: accounting for heterogeneity

Md Al Adib Sarker1, Alireza Rahimi1, Ghazaleh Azimi1

  • 1Department of Civil and Environmental Engineering, Florida International University, Miami, Florida, USA.

Related Concept Videos

Hypothesis Test for Test of Independence01:16

Hypothesis Test for Test of Independence

The test of independence is a chi-square-based test used to determine whether two variables or factors are independent or dependent. This hypothesis test is used to examine the independence of the variables. One can construct two qualitative survey questions or experiments based on the variables in a contingency table. The goal is to see if the two variables are unrelated (independent) or related (dependent). The null and alternative hypotheses for this test are:
H0: The two variables (factors)...
3.6K
Collisions in Multiple Dimensions: Problem Solving01:06

Collisions in Multiple Dimensions: Problem Solving

In multiple dimensions, the conservation of momentum applies in each direction independently. Hence, to solve collisions in multiple dimensions, we should write down the momentum conservation in each direction separately. To help understand collisions in multiple dimensions, consider an example.
A small car of mass 1,200 kg traveling east at 60 km/h collides at an intersection with a truck of mass 3,000 kg traveling due north at 40 km/h. The two vehicles are locked together. What is the...
4.3K
Introduction to Test of Independence01:21

Introduction to Test of Independence

In statistics, the term independence means that one can directly obtain the probability of any event involving both variables by multiplying their individual probabilities. Tests of independence are chi-square tests involving the use of a contingency table of observed (data) values.
The test statistic for a test of independence is similar to that of a goodness-of-fit test:
2.3K
Determination of Expected Frequency01:08

Determination of Expected Frequency

Suppose one wants to test independence between the two variables of a contingency table. The values in the table constitute the observed frequencies of the dataset. But how does one determine the expected frequency of the dataset? One of the important assumptions is that the two variables are independent, which means the variables do not influence each other. For independent variables, the statistical probability of any event involving both variables is calculated by multiplying the individual...
2.2K
Hazard Ratio01:12

Hazard Ratio

The hazard ratio (HR) is a widely used measure in clinical trials to compare the risk of events, such as death or disease recurrence, between two groups over time. It reflects the ratio of hazard rates—the instantaneous risk of the event occurring—between a treatment group and a control group. This measure provides valuable insights into the relative effectiveness of a treatment by assessing how the risk of an event differs between the two groups.
For example, in a clinical trial...
160
Truncation in Survival Analysis01:09

Truncation in Survival Analysis

Truncation in survival analysis refers to the exclusion of individuals or events from the dataset based on specific criteria related to the time of the event. This exclusion can happen in two primary forms: left truncation and right truncation.
Left truncation occurs when individuals who experienced the event of interest before a certain time are not included in the study. This is often due to a "delayed entry" into the study where only those who survive until a certain entry point are...
237