Investigating the thermal and mechanical properties of novel LDPE/TiO₂ and LDPE/TiO₂/CNT composites for 3D printing...

The development of new materials is essential for advancing technology and improving the quality of life. With new materials, we can create products that are stronger, more durable, and more efficient. The ongoing research and development of new materials for 3D printing applications continue to drive innovation in various fields, leading to improved products and processes with great benefits. The main goal of this work was to produce a functional filament with a 1.75-mm diameter that may be used for 3D printing. Composite materials were prepared using a low-density polyethylene (LDPE) resin as polymer matrix, and titanium dioxide (TiO₂) and carbon nanotubes (CNT) as fillers in various ratios. Up to 15 wt% of TiO₂ and 0.25 wt% of CNT were added. Some of the greatest difficulties with high filler content composites are achieving good homogeneity, and in the case of the 3D printing, greatest difficulties are producing the filament with a specific and stable filament diameter. During the 3D printing itself, the fillers can also often cause the nozzle clogging. This paper reports findings of thermal and mechanical properties of the LDPE/TiO₂/CNT composites which are significant for the 3D printing process and the applicability of the composite materials. All of the planed composite materials are successfully prepared and 3D printed into the tensile test specimens. The melting point shift caused by the addition of fillers did not show consistent pattern at differential scanning calorimetry, as all of the samples had melting temperatures around 113.5 ± 1.4 °C. The addition of filler, according to the TGA, increased the threshold temperature for the material decomposition, in case of TiO₂ 5.4 °C increase, while TiO₂ and CNT combination increased the threshold temperature for 6.8 °C. The results of the tensile test show a general increase trend with addition of TiO₂ filler but do not show to a trend for the tensile strength as a result of the addition of CNT filler. The sample with highest TiO₂ filler ratio of 15% (LDPE 15T0C) showed the greatest tensile strength of 14.5 MPa, compared to the 13.0 MPa of pure LDPE. The sample with 5% of TiO₂ filler and 0.1% of CNT filler (LDPE 5T0.1C) showed the greatest elongation of 73.9%, compared to the 68.9% of pure LDPE.