Related Experiment Video
Updated: Jul 20, 2025
Simulator Training for Endovascular Neurosurgery
Published on: May 6, 2020
Simple and Reproducible Microcatheter Shaping Method for Coil Embolization of Medially-directed Paraclinoid Internal
Hiroyuki Matsumoto1, Hirokazu Nishiyama1, Daisuke Izawa1
1Department of Neurological Surgery, Kishiwada Tokushukai Hospital, Kishiwada, Osaka, Japan.
Objective:
It is important to guarantee intra-aneurysmal stability of microcatheters during coil embolization. We developed a simple and reproducible microcatheter shaping method for medially-directed paraclinoid internal carotid artery aneurysms.
Methods:
An injection needle cap was used to make a smooth curve on the mandrel, which was first wound around the back end of the cap to create a primary curve. Next, a secondary curve was created using near the tip of the cap. Thus, a two-dimensional (2D), pigtail-shaped mandrel with a two-stage curve was created. The pigtail-shaped mandrel was inserted from the tip of a straight microcatheter and heat-shaped using a heat gun. Lastly, a microcatheter having a curve whose tip was approximately 6 mm longer than that of the preshaped J was created. We evaluated the ease of navigating the microcatheter into the aneurysm and its stability during coil embolization.
Results:
In all, 34 consecutive medially-directed paraclinoid internal carotid artery aneurysms were treated using the shaped catheters. It took 50-300 seconds (intermediate value: 90 seconds) from inserting the microcatheter with a microguide wire to navigate and place it into an aneurysm. There were no cases that required reshaping of the microcatheters during navigation into the aneurysm. There were no cases that resulted in kickback of the microcatheters from the aneurysm during coil placement, and microcatheter stability was good until the end of the procedure. In all, 12 cases required the balloon-assisted technique and three cases required stent-assisted coiling. The angiographic outcomes immediately after embolization were as follows: 25 cases (73.5%) with complete occlusion; 3 cases (8.8%) with dome filling; and 6 cases (17.6%) with a neck remnant. There were no perioperative complications.
Conclusion:
The shaping method with a pigtail-shaped mandrel using an injection needle cap is simple and reproducible, and is useful for medially-directed paraclinoid internal carotid artery aneurysms.
