Fabrication and characterization of microfluidic devices based on boron-modified epoxy resin using CO₂ laser ablation...

CO₂ laser ablation is a rapid and precise technique for machining microfluidic devices. And also, low-cost epoxy resin (ER) proved the great feasibility of fabricating these devices using the CO₂ laser ablation technique in our previous studies. However, such a technique has shown negative impacts on such ER-based microfluidics as rough surface microchannels, and thermal defects. Therefore, incorporating different proportions of boric acid (BA) into epoxy resin formulation was proposed to obviate the genesis of these drawbacks in ER-based microfluidics. The structural and optical properties of plain ER- and B-doped ER-based chips were characterized by Fourier transform infrared (FT-IR) and UV/Vis spectral analyses. Furthermore, their thermal properties were studied by thermo-gravimetric (TGA) and differential scanning calorimetric (DSC) analysis. A CO₂ laser ablation machine was used in vector mode to draw the designed micro-channel pattern onto plain ER- and B-doped ER-based chips. The quality of microchannels engraved onto these chips was assessed using 3D laser microscopy. This microscopic examination showed a noticeable reduction in the surface roughness and negligible bulge heights in the laser-ablated micro-channels. On the other hand, overall and specific migration using gravimetric methods and gas chromatography-mass spectrometry (GC-MS), respectively, and PCR compatibility test were performed to explore the convenience of these micro-plates for the biological reactions. These findings validated the applicability of B-doped ER-based microfluidics in bio-analytical applications as a result of the effective role of boric acid in enhancing the thermal properties of these chips leading to get micro-channels with higher quality with no effect on the biological reactions.