Related Experiment Video
Updated: Jul 20, 2025

Author Spotlight: Simulation and Analysis of the Temperature Rise of Ring Main Unit Equipment
Published on: July 5, 2024
Does size matter? Modelling the cooling effect of green infrastructures in a megacity during a heat wave
Mikhail Varentsov1, Viacheslav Vasenev2, Yury Dvornikov3
1Research Computing Center, Lomonosov Moscow State University, Moscow, Russia; Hydrometeorological Research Center, Moscow, Russia; Moscow Center for Fundamental and Applied Mathematics, Moscow, Russia.
Abstract:
The vulnerability of urban ecosystems to global climate change becomes a key issue in research and political agendas. Urban green infrastructures (UGIs) are widely considered as a nature-based solution to mitigate climate change and adapt to local urban climate anomalies in cities. However, UGI-induced cooling effect depends on the size, location and geometry of green spaces, and such dependencies remain overlooked. This research aimed to investigate the cooling effect of UGIs of different size under extreme conditions of 2021 summer heat wave for the case of Moscow megacity (Russia) using a numerical mesoclimatic model COSMO. UGIs objects were assigned to one of the four size categories (S, M, L and XL) based on their area. Their cooling effects at the local, non-local and city scales were evaluated based on comparison between the model outcomes for the realistic land cover and simulations for which UGI of a particular size category were replaced by the built-up areas typical for their surroundings. The highest cooling effect was observed for XL size UGIs, which reduced the local heat-wave-averaged air temperatures by up to 3.4 °C, whereas for the S size UGIs it did not exceed 2 °C. The cooling effectiveness for XL category was higher than for S category by 23 % inside the green spaces (locally), by 40-90 % in the buffer zones around the green space (non-locally) and by 35 % for the whole city. More effective cooling of large UGIs is partially explained by their stronger park breeze effect, i.e., impact on the airflow increasing the divergence over green spaces. However, when standardized to the population affected by cooling, the M size UGIs made the strongest contribution to the thermal environment where people live and work. The stronger non-local cooling induced by the largest UGI objects cannot compensate for their remoteness from the built environment.
More Related Videos
11:11Experimental Methods for Investigation of Shape Memory Based Elastocaloric Cooling Processes and Model Validation
Published on: May 2, 2016
10:36Author Spotlight: Optimization of Airflow Velocities in Battery Cooling Systems for Enhanced Thermal Performance and Reduced Energy Consumption
Published on: November 3, 2023
Related Concept Videos
Heating and Cooling Curves
For instance, the addition of heat raises the temperature of a solid; the amount of heat absorbed depends on the heat capacity of the solid (q = mcsolidΔT). According to thermochemistry, the relation between the amount of heat absorbed or released by a substance, q, and its...
Hot Weather Concreting
Mitigating the heat increase in concrete can be economically achieved by shading aggregate stockpiles to prevent heating from solar radiation,...
Mechanisms of Heat Transfer II
Mechanisms of Heat Transfer
Conduction, accounting for approximately 3% of body heat loss at rest, is the process of exchanging heat between molecules of two materials in direct contact. This can result in both heat loss and gain. For instance, when the body is submerged in water, which conducts heat 20 times more effectively than air, it can either lose or gain significant...
Quantifying Heat
Mechanism of heat transfer