Mechanical behaviour of reconstructed defected skull with custom PEEK implant and Titanium fixture plates under...

Skull reconstruction using cranial implants is often required for repairing skull defects caused due to trauma, diseases, or malignancy to protect intracranial structures. For relieving Intracranial Pressure (ICP) surgeons restore cranial defects either using natural bones or fabricated custom cranial implants. With the increase in Traumatic Brain Injuries (TBI) and challenges faced by TBI patients to regain normalcy, it is imperative to analyse the mechanical behaviour of skull-implant assemblies under some Head Injury Criteria (HIC). Medical grade materials including Titanium Alloys (Ti-6Al-4V) and Polyether-ether-ketone (PEEK) are used by fabricating Patient-Specific Implants (PSI) manufactured using 3D imaging, modelling and printing techniques. 3D technologies are preferred over conventional manufacturing methods, as they enable fabrication of custom shapes, sizes and properties for these PSI. For an effective attachment of PSI with a defective skull, a stable joint and plate arrangement as fixture plates is necessary at their interface. These fixtures can have variable numbers, design shapes, materials and location arrangements. This paper presents the Finite Element Method/Analysis (FEM/FEA) study of PSI attached to a defected skull for reconstruction, with linear shaped fixture configuration, when subjected to an external dynamic loading at 5 m/s, strain rate of 10s^-1 to 243s^-1 and ICP of 15mm Hg from three sides of the skull faces. Three different materials as Neoprene (soft), Concrete (medium rigid) and E-Glass (highly rigid) have been used, in the form of a rectangular thin cuboidal wall structure, at an angle of 45° with the skull face. Four linear shaped fixture plates which were simplest to design, were used to attach the PSI-skull assembly, to ensure that weight of the PSI-fixation assembly on the patient remains minimal, overall assembly has symmetrical fixations and efforts required by a surgeon for fitment of these plates remain minimal. Placement of these fixture plates has been optimized to encompass the complete PSI-skull interface section, due to which the stresses within all the assembly components (PSI, fixture plate and skull) reduced by nearly 2.5 times than the initial design and remained within yielding limits, thereby, averting any failure under heavy external dynamic loading.