Strengthening Mechanisms and Retention Properties of Sintered Iron-Based Matrix Material for Metallic-Diamond Tools

This work presents the analysis of mechanisms controlling the deformation strengthening of the surface during abrasion and their impact on structural changes and mechanical properties of Fe-Mn-Cu-Sn-C matrix material, which was prepared by means of powder metallurgy (PM). The powder mixture was ball-milled for 8 h and densified to <1% porosity using hot pressing at 900 °C and 35 MPa. Phases and structural transformations taking place in austenite during plastic deformation were identified. The participation, distribution, and morphology of the phases, as well as the physicomechanical properties of the matrix material, were tested. It has been shown that during grinding, deformation twins are generated in areas where an austenitic microstructure is present. To test the ability of the matrix to keep diamond crystals firmly cylindrical (Ø11.3 mm× 5 mm), diamond-impregnated specimens containing diamond grits of 30/40 mesh in size and at a concentration of 20 (5% vol.) were prepared. It was finally determined by the diamond-retention index, which is the number of retained diamond particles compared to the total number of diamond particles and the pullouts on the working surface of the segment. This research shows that materials containing Ti- and Si-coated diamond particles, deposited by the CVD method, have the highest abrasion resistance and, therefore, have the best retention properties. In order to determine the bonding mechanism at the matrix-diamond interface, specimens were also analyzed by SEM and TEM.