Assessment of Stress Levels in Lactating Cattle: Analyzing Cortisol Residues in Commercial Milk Products in Relation

Mohammad Ataallahi1, Si Nae Cheon2, Geun-Woo Park1

  • 1Department of Animal Industry Convergence, Kangwon National University, Chuncheon 24341, Republic of Korea.

Related Concept Videos

Responses to Heat and Cold Stress02:45

Responses to Heat and Cold Stress

Every organism has an optimum temperature range within which healthy growth and physiological functioning can occur. At the ends of this range, there will be a minimum and maximum temperature that interrupt biological processes.
13.6K
Introduction to Stress and Lifestyle01:27

Introduction to Stress and Lifestyle

Stress is a multifaceted response to events perceived as challenging or threatening, highlighting physical, emotional, cognitive, and behavioral reactions. Physically, stress can lead to fatigue, sleep disruptions, and various health issues such as frequent colds, chest pains, and nausea. Emotionally, it can manifest as anxiety, depression, irritability, and anger triggered by both minor and major life events. Cognitively, it may result in difficulty in concentration, memory, and...
144
Assessing Body Temperature - Rectal01:27

Assessing Body Temperature - Rectal

Rectal temperature measurement is considered the most precise method for assessing core body temperature and typically registers higher than oral temperature. For adults, the rectal thermometer should be inserted 1 to 1.5 inches into the rectum to obtain the most accurate reading.
Follow these steps for rectal temperature assessment:
Step 1: Perform hand hygiene and don clean gloves to prevent cross-infection.
Step 2: Position the patient in a side-lying position to better visualize the rectal...
4.6K
Stress Concentrations01:13

Stress Concentrations

The concept of stress concentration is crucial for understanding how materials respond under bending stresses, particularly when there are irregularities or discontinuities in the material's geometry. Normally, stress in a symmetric member subjected to pure bending is assumed to be uniformly distributed across the entire cross-section. However, this assumption does not hold when there are variations in the cross-sectional geometry or the presence of notches and holes.
The stress...
255