The mechanical properties and sustainability of phosphogypsum-slag binder activated by nano-ettringite

The cementitious material based on phosphogypsum (PG) and ground granulated blast furnace slag (GBFS) demonstrates good economy and sustainability, whereas its drawback of ultra-slow strength development seems unacceptable. In this study, an attempt to drive the hydration of PG-GBFS and further facilitate the strength development by introducing nano-ettringite (NE) was carried out. The impact of 1- 5 % NE on the compressive strength, hydration process, dissolution behavior, and microstructure evolution of PG-GBFS were investigated. The results showed that the incorporation of NE significantly increased the compressive strength of PG-GBFS. At 7 d, the strength grew from 0 MPa to a range of 7.6- 20.2 MPa, and at 28 d, it was enhanced from 22.9 MPa to a range of 45.6- 79.0 MPa. The reason was that the introduction of NE induced the formation of AFt, thereby accelerating the hydration process and promoting the development of the skeletal network, resulting in higher early strength. Besides, NE facilitated the formation of C-S(A)-H gel, which further refined the pore structure and led to continuous growth in later strength. Additionally, PG-GFBS with 5 % NE exhibited significantly lower total costs (35.0 % of NaOH-activated slag and 51.7 % of water glass-activated slag) and lower carbon emissions (30.8 % of NaOH-activated slag and 49.8 % of water glass-activated slag) at the same 28 d compressive strength, indicating its strong competitiveness in both sustainability and economy.