Method for the Determination of Oxygen in FLiBe via Inert Gas Fusion

In nuclear reactors that use molten fluoride salts, either as coolants or as the medium for the fuel, the purity of the salts is critical for controlling salt chemistry and mitigating corrosion. Water is a particularly important contaminant in this regard, as it participates in a number of important corrosion reactions, so the careful measurement of oxygen, which is principally present in the salts due to water contamination, is a critical step in salt characterization. Here, we present an analytical method for quantifying oxygen contamination in Li₂BeF₄ (FLiBe), a technologically important and suitably representative fluoride salt, with a detection limit of 22 μg of oxygen, or 110 ppm in a 200 mg sample. To test the method, four FLiBe samples from different batches were tested. Two of these showed oxygen concentrations below the method detection limit, while two showed concentrations above it. In particular, the difference in the oxygen concentration between purified and un-purified batches of material from Kairos Power showed the efficacy of this method in characterizing the degree of oxygen removal obtained from purification methods.