Related Experiment Video
Updated: Aug 11, 2026
Dorsal Column Steerability with Dual Parallel Leads using Dedicated Power Sources: A Computational Model
Published on: February 10, 2011
Analysis of spinal canal diameter in the placement of thoracic spinal cord stimulator paddle leads
Brian T Ragel1, Tressa Riedman1,2, Matthew McGehee2
1Division of Neurosurgery, Rebound Orthopedics and Neurosurgery, Portland, Oregon, USA.
Background:
Neurologic deficit is known as a rare complication of thoracic spinal cord stimulator (SCS) paddle lead implantation, but many believe its incidence after SCS paddle lead placement is under-reported. It is possible that imaging characteristics may be used to help predict safe paddle lead placement.
Objective:
This imaging study was undertaken to determine the minimum canal diameter required for safe paddle lead placement.
Methods:
Patients who underwent thoracic laminotomy for new SCS paddle lead placement from January 2018 to March 2023 were identified retrospectively. Preoperative thoracic canal diameter was measured in the sagittal plane perpendicular to the disc space from T5/6 to T11/12. These thoracic levels were chosen because they span the most common levels targeted for SCS placement. Patients with and without new neurologic deficits were compared using a Mann-Whitney U-test.
Results:
Of 185 patients initially identified, 180 had thoracic imaging available for review. One (0.5%) and 2 (1.1%) of 185 patients complained of permanent and transient neurologic deficit after thoracic SCS placement, respectively. Patients with neurologic deficits had average canal diameters of <11 mm. The average canal diameter of patients with and without neurologic deficits was 10.2 mm (range 6.1-12.9 mm) and 13.0 mm (range 5.9-20.2), respectively (p < 0.0001).
Conclusion:
Postoperative neurologic deficit is an uncommon complication after thoracic laminotomy for SCS paddle lead placement. The authors recommend ensuring a starting thoracic canal diameter of at least 12 mm to accommodate a SCS paddle lead measuring 2 mm thick to ensure a final diameter of >10 mm. If canal diameter is <12 mm, aggressive undercutting of the lamina, a second laminotomy, or placement of smaller SCS wire leads should be considered.
