Related Experiment Video
Updated: Jul 18, 2025

Watershed Planning within a Quantitative Scenario Analysis Framework
Published on: July 24, 2016
Prediction of water quality under the impacts of fine dust and sand storm events using an experimental model and
Majid Galoie1, Artemis Motamedi2, Jihui Fan3
1Civil Engineering Department, Imam Khomeini International University, Qazvin, 34148-96818, Iran.
Abstract:
Many regions of the world, especially arid and semiarid areas, occasionally experience fine dust and sandstorms, known environmental problems that make normal life difficult. Since the intrusion of large amounts of dust into treatment plants may significantly change the water quality indices, the main goal of this study was to estimate these indices during the events, which can help decision-makers to improve water quality. To achieve relationships using nonlinear multivariate regression analysis, a long-term (three years: April 2017-February 2020) experimental study of water quality parameters including total dissolved solids (TDS), hydrogen content (pH), electrical conductivity (EC), chlorine (Cl), total hardness, sodium (Na), and magnesium (Mg) for water samples from wastewater treatment plants in Sistan region (Iran) was conducted where is one of the most popular regions in the world with high amount of annual fine dust level. Analysis of ANOVA showed that of all the independent parameters considered in this study, water quality parameters strongly correlated with monthly mean sand and dust storm index (SDSI), wind speed, temperature, and the number of monthly windy days. For the regression analysis, 25 months of data were used for the simulation process and 10 months for validation. The final results showed that the relationships obtained from the nonlinear multivariate regression analysis could predict the water quality indices very well (with R2 more than 0.75) except for Mg with R2 equal to 0.55. In addition, the maximum mean relative error belongs to Mg (10.8%) and then Na (9.9%) whereas the minimum mean relative error belongs to pH (2.6%) and then EC (2.9%).
More Related Videos
12:26Integrating Remote Sensing with Species Distribution Models; Mapping Tamarisk Invasions Using the Software for Assisted Habitat Modeling SAHM
Published on: October 11, 2016
07:47Experimental Protocol to Investigate Particle Aerosolization of a Product Under Abrasion and Under Environmental Weathering
Published on: September 16, 2016
Related Concept Videos
Multiple Regression
Farmers can use multiple regression to determine the crop yield based on more than one factor, such as water availability, fertilizer, soil properties, etc. Here, the crop yield is the response or dependent variable as it depends on the other independent variables. The analysis requires the construction of a scatter plot...
Typical Model Studies
Design Example: Aggregate Gradation
The grading, or particle-size distribution, of sand is determined using sieve analysis, with standard sizes ranging from 150 μm to 10 mm (ASTM No. 100 sieve to 3⁄8 in. sieve). Sand is...
Regression Analysis
In regression analysis, a regression equation is determined based on the line of best fit– a line that best fits the data points plotted in a graph. This line is also called the regression line. The algebraic equation for the regression line is called the regression equation. It is represented as: