Related Experiment Video

Updated: Jul 17, 2025

Recombination Dynamics in Thin-film Photovoltaic Materials via Time-resolved Microwave Conductivity
11:30

Recombination Dynamics in Thin-film Photovoltaic Materials via Time-resolved Microwave Conductivity

Published on: March 6, 2017

11.7K

Recurrence recovery in heterogeneous Fermi-Pasta-Ulam-Tsingou systems

Zidu Li1, Mason A Porter2,3, Bhaskar Choubey1

  • 1Department of Electrical Engineering and Computer Science, University of Siegen, Siegen, North Rhine-Westphalia 57072, Germany.

Chaos (Woodbury, N.Y.)
|September 7, 2023
PubMed

More Related Videos

Cooling an Optically Trapped Ultracold Fermi Gas by Periodical Driving11:21

Cooling an Optically Trapped Ultracold Fermi Gas by Periodical Driving

Published on: March 30, 2017

7.5K
Measurement of Coherence Decay in GaMnAs Using Femtosecond Four-wave Mixing15:58

Measurement of Coherence Decay in GaMnAs Using Femtosecond Four-wave Mixing

Published on: December 3, 2013

5.8K

Related Concept Videos

Fermi Level Dynamics01:12

Fermi Level Dynamics

The vacuum level denotes the energy threshold required for an electron to escape from a material surface. It is usually positioned above the conduction band of a semiconductor and acts as a benchmark for comparing electron energies within various materials.
Electron affinity in semiconductors refers to the energy gap between the minimum of its conduction band and the vacuum level and it is a critical parameter in determining how easily a semiconductor can accept additional electrons.
The work...
278
Conservative Site-specific Recombination and Phase Variation02:53

Conservative Site-specific Recombination and Phase Variation

Because the DNA segments are cut and reorganized in a direction-specific manner, site-specific recombination has emerged as an efficient genetic engineering technique. Flippase and Cyclization recombinases or Flp and Cre, respectively, are two members of the tyrosine recombinase family derived from bacteriophages, that are used to mediate site-specific DNA insertions, deletions, and targeted expression of proteins in mammalian cell lines.
The recognition sites for Cre recombinase called LoxP...
6.0K
Propagation of Uncertainty from Random Error00:59

Propagation of Uncertainty from Random Error

An experiment often consists of more than a single step. In this case, measurements at each step give rise to uncertainty. Because the measurements occur in successive steps, the uncertainty in one step necessarily contributes to that in the subsequent step. As we perform statistical analysis on these types of experiments, we must learn to account for the propagation of uncertainty from one step to the next. The propagation of uncertainty depends on the type of arithmetic operation performed on...
724
Propagation of Uncertainty from Systematic Error01:10

Propagation of Uncertainty from Systematic Error

The atomic mass of an element varies due to the relative ratio of its isotopes. A sample's relative proportion of oxygen isotopes influences its average atomic mass. For instance, if we were to measure the atomic mass of oxygen from a sample, the mass would be a weighted average of the isotopic masses of oxygen in that sample. Since a single sample is not likely to perfectly reflect the true atomic mass of oxygen for all the molecules of oxygen on Earth, the mass we obtain from this...
552
Restarting Stalled Replication Forks02:37

Restarting Stalled Replication Forks

DNA replication is initiated at sites containing predefined DNA sequences known as origins of replication. DNA is unwound at these sites by the minichromosome maintenance (MCM) helicase and other factors such as Cdc45 and the associated GINS complex.The unwound single strands are protected by replication protein A (RPA) until DNA polymerase starts synthesizing DNA at the 5’ end of the strand in the same direction as the replication fork. To prevent the replication fork from falling apart,...
5.8K
Entropy Change in Reversible Processes01:10

Entropy Change in Reversible Processes

In the Carnot engine, which achieves the maximum efficiency between two reservoirs of fixed temperatures, the total change in entropy is zero. The observation can be generalized by considering any reversible cyclic process consisting of many Carnot cycles. Thus, it can be stated that the total entropy change of any ideal reversible cycle is zero.
The statement can be further generalized to prove that entropy is a state function. Take a cyclic process between any two points on a p-V diagram.
2.6K