Revisiting the transorbital approach for emergency external ventricular drainage: an anatomical study of relevant...

The transorbital approach (TOA) can provide immediate access to the lateral ventricles by piercing the roof of the orbit (ROO) with a spinal needle and without the need of a drill. Reliable external landmarks for the TOA ventriculostomy have been described, however, the necessary spinal needle gauge and other relevant parameters such as the thickness of the ROO have not been evaluated. Nineteen formalin-fixed adult cadaveric heads underwent the TOA. Spinal needles of different gauges were consecutively used in each specimen beginning with the smallest gauge until the ROO was successfully pierced. The thickness of the ROO at the puncture site and around its margins was measured. Other parameters were also measured. The TOA was successfully performed in 14 cases (73.68%), where the most suitable needle gauge was 13 (47.37%), followed by a 10-gauge needle (36.84%). The mean thickness of the ROO at the puncture site, and the mean length of the needle to the puncture site were 1.7 mm (range 0.2-3.4 mm) and 15.5 mm (range 9.2-23.4 mm), respectively. A ROO thickness of greater than 2.0 mm required a 10-gauge needle in seven cases, and in five cases, a 10-gauge needle was not sufficient for piercing the ROO. The presence of hyperostosis frontalis interna (HFI) (21.05%) was related to the failure of this procedure (80%; p < 0.00). Using a 13/10-gauge spinal needle at Tubbs' point for TOA ventriculostomy allowed for external ventricular access in most adult specimens. The presence of HFI can hinder this procedure. These findings are important when TOA ventriculostomy is considered.