Cost hierarchies and the pattern of product cost cross-subsidization: Extending a computational model of costing

Mark Schmidt1, Kai Gustav Mertens1, Matthias Meyer1

  • 1Institute of Management Accounting and Simulation, Hamburg University of Technology, Hamburg, Germany.

Plos One
|September 11, 2023
PubMed

Related Concept Videos

Cross Product01:25

Cross Product

The cross product is a fundamental concept in vector algebra that is a vector operation on two different vectors to obtain a third vector. Unlike the scalar product, the cross product results in a vector quantity perpendicular to both the original vectors.
The magnitude of the cross product is obtained by multiplying the magnitude of both the vectors and the sine of the angle between them. This means that a larger angle between the vectors will lead to a greater magnitude of the cross product.
280
Factorial Design02:01

Factorial Design

Factorial Analysis is an experimental design that applies Analysis of Variance (ANOVA) statistical procedures to examine a change in a dependent variable due to more than one independent variable, also known as factors. Changes in worker productivity can be reasoned, for example, to be influenced by salary and other conditions, such as skill level. One way to test this hypothesis is by categorizing salary into three levels (low, moderate, and high) and skills sets into two levels (entry level...
13.1K
Ratio Level of Measurement00:54

Ratio Level of Measurement

The way a set of data is measured is called its level of measurement. Correct statistical procedures depend on a researcher being familiar with levels of measurement. For analysis, data are classified into four levels of measurement—nominal, ordinal, interval, and ratio.
A set of data measured using the ratio scale takes care of the ratio problem and provides complete information. Ratio scale data are like interval scale data, except they have a zero point and ratios can be calculated....
18.4K
Predicting Products: Substitution vs. Elimination02:52

Predicting Products: Substitution vs. Elimination

When a nucleophile and an alkyl halide react, nucleophilic substitution and β-elimination reactions compete to generate products.
The following factors can influence the mechanisms competing against each other:
11.8K
Crossover Experiments01:16

Crossover Experiments

Crossover experiments, also called the repeated-measurements design, is a study design in which all experimental units are exposed to all treatments in different periods. Crossover experiments are generally used in psychology, the pharmaceutical industry, agriculture, and medicine.
Crossover designs are performed even with smaller sample sizes since the samples can act as their controls. These are better than simple randomized trials since patients are exposed to all the treatments.
2.9K
Relative Frequency Histogram01:14

Relative Frequency Histogram

The relative frequency depicts the proportion of data points that have each value. The frequency tells the number of data points that have each value. Like the histogram, a relative frequency histogram also has the same shape with a horizontal scale (the x-axis), but the vertical scale (the y-axis) is marked with relative frequencies (percentages of the whole) instead of actual frequencies. A relative frequency histogram is a graphical representation of a frequency distribution where the...
5.5K