Congener-Specific Emissions from Floors and Walls Characterize Indoor Airborne Polychlorinated Biphenyls

To reconcile the federal regulation of material polychlorinated biphenyl (PCB) concentrations with recently implemented state regulations of airborne PCBs, there is a need to characterize the relationship between PCB emissions from surfaces and air concentrations. We hypothesized that the magnitude and congener distribution of emissions from floors and walls fully account for the airborne PCBs measured in rooms constructed during the height of PCB production and sales. We measured emissions of PCB congeners from various wall and floor materials using polyurethane foam passive emission samplers before and after hexane wiping. Our results revealed that PCB emissions from flooring adequately predicted the magnitude and congener distribution of PCBs observed in the room air. Emissions varied by material within a single building (5 × 10³ ng m^-2 day^-1 from wood panel walls to 3 × 10⁴ ng m^-2 day^-1 from vinyl tile) and within the same room. Yet congener distributions between material emission PCB profiles and room air PCB profiles were statistically similar. Hexane wiping significantly reduced PCB emissions (>60%), indicating the importance of surface films as an ongoing source of airborne PCBs. The magnitude and congener distribution of material bulk concentrations did not explain that of material emissions or air concentrations. Passive measurements of polychlorinated biphenyl emissions from floors in a university building predict the concentrations of PCBs in room air.