Palliative intensity modulated radiotherapy of bone metastases based on diagnostic instead of planning computed...

Radiotherapy (RT) treatment planning is as a standard based on a computed tomography (CT) scan obtained at the planning stage (pCT), while most of the decisions whether to treat by RT are based on diagnostic CT scans (dCT). Bone metastases (BM) are the most common palliative RT target. The objective of this study was to investigate if a palliative RT treatment plan of BMs could be made based on a dCT with sufficient accuracy and safety, without sacrificing any treatment quality.

A retrospective study with 60 BMs of 8 anatomical sites was performed. RT planning was performed using intensity-modulated radiation therapy/volumetric modulated arc therapy techniques in dCT and transferred to pCT. The dose of clinical target volumes (CTVs), D(CTV_{V95%, V50%}), were compared between plans for dCT and pCT. Patient setup was investigated in cone-beam CT scans.

The differences of D(CTV_{V95%, V50%}) between dCT and pCT plans were the lowest in the pelvis (1.0%, 1.1%), lumbar spine (0.6%, 0.7%) and thoracic spine (0.7%, 2.1%), while the differences were higher in cervical spine (3.7%, 1.9%), long bones (2.3%, 0.8%), and costae (1.6%, 1.4%). The patient set-up was acceptable for 100% of the pelvic and lumbar, for 92% of thoracic spine cases, and for <80% of cases in other sites.

This study showed the feasibility of using dCT images in palliative RT planning of BMs in thoracic, lumbar spine and pelvic sites, indicating the potential suitability of this strategy for clinical use.