Effect of 3 Different Set Configurations on Kinematic Variables and Internal Loads During a Power Snatch Session

Nagatani, T, Kendall, KL, Guppy, SN, Poon, WCK, and Haff, GG. Effect of 3 different set configurations on kinematic variables and internal loads during a power snatch session. J Strength Cond Res 37(10): 1929-1938, 2023-The aim of this study was to investigate the effect of 3 different set configurations on kinematic variables and internal loads during multiple sets performed with the power snatch. Ten strength-power athletes with at least 6 months of training experience performing the power snatch participated in this study, which consisted of 3 experimental protocols performed in a randomized repeated-measures design. The 3 protocols involved performing the power snatch for 3 sets of 5 repetitions at an average load of 75% 1 repetition maximum with a traditional (TRAD), cluster (CLU), or ascending cluster (A-CLU) protocol, where the training load was progressively increased across the set. Kinematic variables and internal loads (heart rate, blood lactate, and rate of perceived exertion) were measured during each protocol. The athletes maintained peak velocity (PV) and peak power (PP) and exhibited lower internal loads during CLU sets when compared with TRAD sets, whereas they displayed significant decreases in PV during TRAD sets. However, there were no statistically significant differences in PV and PP responses between the TRAD and CLU protocol. The athletes exhibited a significant decrease in PV, whereas PP was increased across each set in the A-CLU protocol, with lower internal loads observed compared with the TRAD protocol. Overall, the training loads used in this study do not appear to maximize the benefits of using CLU set during 3 sets of power snatches performed for 5 repetitions. In addition, A-CLU sets may potentially be useful as a means of maximizing the power output of the athlete.