Computational modelling of the fossa component fixation associated with alloplastic total temporomandibular joint...

The alloplastic total temporomandibular joint (TMJ) replacement is a complex surgical approach to end-stage TMJ disorders. The fixation of TMJ prostheses remains a critical issue for implant design and performance. For the fossa component, it is generally considered to use fixation screws to achieve tripod stability. However, the fossa may still come loose, and the mechanism remains unknown. A computational framework, consisting of a musculoskeletal model for calculating muscle and TMJ forces, and a finite element model for the fossa fixation simulation, was developed. A polyethylene (PE) fossa with stock prosthesis design was analyzed to predict contact pressures at the fixation interfaces, and stresses/strains in the fossa implant and bone during the static loading of normal chewing bite and maximum-force bite. The predicted maximum von Mises stresses were 33 MPa and 44 MPa for the bone, 13 MPa and 28 MPa for the PE fossa, and 131 MPa and 244 MPa for the screws, for the normal and maximum bites, respectively; the peak minimum principal strain was in the range of -2514 ∼ -3545 με for the bone. The results show that the sufficient initial mechanical strength of the fossa component fixation can be established using the screws in combination with bone support. The functional loads applied through the prosthetic TMJ bearing can be largely transferred to supporting bone without causing high level stresses. Tightening fixation screws with a pretension of 100 N can reduce transverse load to the screws and help prevent screw loosening. Further research is recommended to accurately quantify the transverse load and its influence on screw loosening during dynamic loading, and the frictional properties at the bone-implant interface.