Finite element simulation study on vertical bearing characteristics of single pile with ram-compacted bearing sphere

The pile with ram-compacted bearing sphere (PRBS)is a kind of special-shaped pile, the calculation formula of single pile bearing capacity stipulated in Chinese Standards JGJ/T 135-2018 is relatively simple, and the factors considered are not comprehensive enough. This article uses the finite element simulation software ABAQUS to simulate and calculate the compressive bearing characteristics of PRBS, and studies the changes in the vertical bearing characteristics of PRBS under different factors and working conditions (different pile lengths, pile diameters, and the diameters of ram-compacted bearing sphere (RBS)). The calculation results indicate that the PRBS still has a large axial force near the enlarged end of the pile bottom, and the RBS bears a large load. The vertical bearing capacity of the PRBS is mainly provided by the RBS, but the pile side friction still has a certain degree of influence on its bearing capacity. The maximum ratio of pile side frictional resistance to applied load can reach 18.41%. Compared with the ordinary pile, the bearing capacity of the PRBS is significantly improved. The ultimate bearing capacity of the PRBS with the RBS diameter of 1m is more than 5 times that of the ordinary pile under the same condition. Pile diameter has little influence on the bearing capacity of PRBS, while the change of RBS diameter has great influence on the bearing capacity of single pile. However, when the RBS diameter is too large, it is easy to cause the uplift of surrounding soil in the construction process and affect surrounding piles. Therefore, it is suggested that the optimal RBS diameter should be 800mm~1200mm. This study provides reference suggestions for the study of piles with ram-compacted bearing sphere.