A Study on the Influence of Process Parameters on the Workpiece Surface Quality in the Cutting of Hard and Brittle...

Hard and brittle materials have excellent physical and mechanical properties and are widely used in the fields of microelectronics and optoelectronics. However, due to their high hardness and brittleness, the machining quality of a workpiece struggles to meet the requirements of practical applications. In order to improve the surface quality of deep-hole machining of hard and brittle materials, this article analyzes the formation mechanism of surface roughness and the exit-chipping width during the drilling machining of hard and brittle materials and establishes a mathematical prediction model for the surface roughness and the exit-chipping width of hard and brittle materials using a trepanning cutter. The experimental study on K9 optical glass machining shows that the surface roughness of the workpiece and the exit-chipping width increase with the increase in feed rate, and decrease with the increase in rotational speed. Through comparison and verification between theoretical and experimental values, the average errors of workpiece surface roughness and the exit-chipping width are 13.15% and 6.73%, respectively. This article analyzes the reasons for the errors. The results indicate that the theoretical model proposed in this article can be used to predict the surface roughness and the exit-chipping width of hard and brittle materials processed under the same conditions, providing a theoretical basis to optimize process parameters to improve the surface quality of the workpiece.