Analysis of surface deposits on intrauterine contraceptive devices

Surface deposits on stainless steel contraceptive devices removed from the uterus after varying periods of insertion were examined and analyzed by means of scanning electron microscopy (SEM), X-ray energy dispersive analysis (XEDA), Augar electron spectroscopy (AES), X-ray photoelectron spectroscopy (XPS), transmission electron microscopy (TEM) and atomic absorption spectrophotometry for microquantitative analysis. The data obtained were compared with the data for copper-bearing IUDs (TCu200) obtained by the same method. The wire coils of stainless steel IUDs which had been in situ for 5 years showed no obvious changes, but copper wire coils showed varying degrees of erosion after the same period of time. Analysis clearly showed that the wire coils of both types of IUD were encrusted with deposits. Deposition began earlier on copper-bearing IUDs than on stainless steel IUDs (27 days and 3 months after insertion, respectively). This process began earlier than has previously been reported in the literature. The amount of deposit increased with duration of insertion, but there were large individual variations. The microanalysis showed that the principal component of the deposit on both types of IUD was calcium, which was present in the crystal form of calcium carbonate. The substances attaching to the crystals were similar to the nitrogenous organic compounds. We suggest that the mechanism regulating the deposited formation may be similar to that of calculus. The influence of these deposits on complications relating to IUD insertion, such as uterine bleeding and accidental pregnancy, is briefly discussed in this article. The subject should be studied in greater detail.