Preparation of light-colored bio-based particles by isocyanate-modified lignins and its application for tetracycline...

A practical method for the preparation of lignin derivatives-light-colored bio-based particles (LC-BP) via the modification of hexamethylene diisocyanate (HDI) is presented in this work. In the mixed EtOH/H₂O system, the change of solvent polarity induced the self-assembly of the lignosulfonate (LS) with the hydrophobic chromophores encapsulated inside the particles. The color of LS was reduced by the polymerization between the isocyanate groups (-N=C=O) of HDI and hydroxy groups of LS. Compared with the typical lignin-based adsorbent preparation process in the past, this is a simple, direct, and efficient preparation method and the synthetic LC-BP has good chemical stability and resistance to heat, acid and alkali. This effectively solves the problem that LS has high water solubility and is difficult to use directly for wastewater treatment. To investigate the properties, the synthetic LC-BP was characterized by SEM, specific surface area, L*a*b* (CIELAB) color space, FT-IR, XPS, and TGA. The results showed that the LC-BP exhibited obvious advantages in color reduction with a low CIE-L* value. The LC-BP exhibits a scale-like intercalation structure, which makes it a promising candidate for adsorbing tetracycline (TC) from wastewater. The conditions of pH, adsorbent dosages, adsorption time, and initial TC concentration were investigated, and the adsorption performance of LC-BP for TC was significantly better than that of conventional polyurethane particles (PP). The adsorption fitted the Langmuir model and there were hydrogen bonding, π-π conjugated binding, and electrostatic attraction during the absorption process. The adsorption capacity was up to 53.1 mg/g, and the removal rate was 67 %. The utilization of LC-BP, a low-cost, effective, and renewable resource derived from natural biomass, holds immense practical and economic potential in wastewater treatment.