A neutron beam monitor based on ceramic gas electron multiplier with high spatial resolution for low flux...

Neutron scattering instruments play an important role in studying the inner structure of materials. A neutron beam monitor is a detector commonly used in a neutron scattering instrument. The detection efficiency for most neutron beam monitors is quite low (10-4-10-6). However, in some experiments with a low neutron flux, such as small angle neutron scattering (SANS) and inelastic neutron scattering experiments, a neutron beam monitor with a higher detection efficiency (∼1% for thermal neutrons) is required to reduce the duration of the experiment. To meet this requirement, a ceramic gas electron multiplier-based neutron beam monitor equipped with a 1 µm 10B4C neutron converter was developed in this study. Its performance was determined both experimentally and in simulations. The detection efficiency in the wavelength range of 1.8-5.5 Å was measured experimentally and was confirmed by the simulation results. An algorithm based on event selection and position reconstruction was developed to improve the spatial resolution to about 1 mm full-width-half-maximum. The wavelength spectrum was measured in beamline 20 (BL20) and agreed well with the results obtained using a commercial monitor. The maximum counting rate was 1.3 MHz. The non-uniformity over the whole 100 × 100 mm2 active area was determined to be 1.4%. Due to the excellent performance of this monitor, it has been used in several neutron instruments, such as the SANS and the High-Energy Direct-Geometry Inelastic Spectrometer instruments in the China spallation neutron source.