In engineering applications, the representation of the numerical value is critical. Presenting or reporting the answer is one of the essential parts of engineering practices. Numerical calculations are performed using handheld calculators or computers since numerically accurate answers are always preferred.
The solution to a problem is obtained using different methods. While manually solving algebraic symbols is one of the most common methods, the graphical method is often preferred. Computers...

Uncertainty in measurements can be avoided by reporting the results of a calculation with the correct number of significant figures. This can be determined by the following rules for rounding numbers:

Sometimes, there is a need to convert from one unit to another one. For instance, reading a cookbook in which quantities are expressed in units of liters or ounces may require conversion of quantities to cups. Or, when looking up directions on how to get to a location, we may be interested to know how many miles we are going to walk. In this case, we would have to convert units of feet or meters to miles.
The first step in the unit conversion is to list the given units and the units required...

In any measurement, the precision of the measuring tool is an essential factor. An ordinary ruler, for example, can measure length to the closest millimeter; a caliper, on the other hand, can measure length to the nearest 0.01 mm. As a result, the caliper is a more precise measurement tool because it can measure extremely minute changes in length. The measurements will be more accurate if the measuring tool is more precise.
It should be emphasized that when we represent measured values, the...

Dimensional analysis, also known as the factor label method, is a versatile approach for mathematical operations. The main principle behind this approach is: the units of quantities must be subjected to the same mathematical operations as their associated numbers. This method can be applied to computations ranging from simple unit conversions to more complex and multi-step calculations involving several different quantities and their units.
Conversion Factors and Dimensional Analysis
The unit...

All the digits in a measurement, including the uncertain last digit, are called significant figures or significant digits. Note that zero may be a measured value; for example, if a scale that shows weight to the nearest pound reads “140,” then the 1 (hundreds), 4 (tens), and 0 (ones) are all significant (measured) values.