Study on water and oxygen transfer characteristics of HT-PEM fuel cells

In this study, a steady-state model is developed by combining mechanical, Navier-Stokes, Maxwell-Stefan, and Butler-Volmer equations. This model is then used to investigate the influences of diffusion layer thickness deformation under a specific assembly force on the porosity distribution as an indicator of fuel cell performance. The HT-PEM (high temperature proton exchange membrane) fuel cell model is built using COMSOL Multiphysics software, simulating the changes in diffusion layer porosity under different thicknesses of the diffusion layer, thus analyzing the trends in variation of water and oxygen concentration in the cathode diffusion layer. The battery has different current densities at different operating potentials. The influence of the working potential on the mass transfer concentration and the variation in the mass transfer concentration of the diffusion layer under the different areas of flow channel and flow ridge is discussed. The simulation results have a certain reference value for the optimization of mass transfer in a diffusion layer. The results reveal the combined effect of the assembly force and flow field, which makes the porosity distribution uneven and results in remarkable lateral current in the gas diffusion layer (GDL). The thicker the diffusion layer, the less oxygen consumed, and a large amount of oxygen is retained in the gaseous diffusion layer. It can be concluded that thicker diffusion layer is conducive to more uniform mass transfer and diffusion. These results can potentially be used to promote the performance and application of HT-PEMFC.