Related Experiment Video
Updated: Jul 13, 2025

Parameterizing V-notch Weir Equations for Flow Monitoring in a Drainage Control Structure
Published on: April 25, 2025
Sewage network operational risks based on InfoWorks ICM with nodal flow diurnal patterns under NPIs for COVID-19
Jinjun Zhou1, Yali Pang1, Hao Wang1
1Faculty of architecture, civil and transportation engineering, Beijing University of Technology, Beijing 100124, China.
Abstract:
Non-Pharmaceutical Interventions (NPIs) have been widely employed globally over the past three years to control the rapid spread of coronavirus disease 2019 (COVID-19). These measures have imposed restrictions on urban residents' activities and significantly influenced sewage discharge characteristics within sewage network, particularly in densely populated cities in China. This study focused on the nodal flow diurnal patterns and sewage network operational risks before and after epidemic lockdown in Beijing from March to May in 2022. Nodal flow diurnal patterns on weekdays and weekends before and after NPIs were analyzed using measured data through statistical and mathematical methods. A sewage network model was established to simulate and analyze the operational risks based on InfoWorks ICM before and after epidemic lockdown. The main conclusions were as follows: (1) In predominantly residential areas, the total wastewater volume increased by approximately 28.76 % to 33.52 % after the implementation of strict NPIs. The morning and midday "M" peaks on normalized weekdays transformed into "N" peaks, and the morning peak time was delayed by 0.5 to 1 hour after the lockdown; (2) Following NPIs, More than 90 % of manholes' average water levels rose to varying degrees, approximately 50 % of pipe lengths exhibited a full flow state; (3) When the lockdown was in place during a hot summer day, sewage overflow phenomena were observed in 4.6 % and 9.6 % of manholes, respectively, with per capita daily drainage equivalent reaching 40-50 %. These findings hold significant implications for the proactive planning and operational management of water industry infrastructure during major emergencies.
Related Concept Videos
Design Example: Analyzing Capacity Contours for Flood Risk Assessment
Multiple Pipe Systems
Series Configuration
In a series configuration, fluid flows sequentially from one pipe...
Rapidly Varying Flow
Steps in Outbreak Investigation
Design Example: Design of an Irrigation Channel
Single Pipe Systems
In a Type I problem, fluid properties (density and viscosity), pipe characteristics (including diameter, length, and surface roughness), and the flow rate or average velocity are...

