Related Experiment Video
Updated: Jul 13, 2025

Pool-Boiling Heat-Transfer Enhancement on Cylindrical Surfaces with Hybrid Wettable Patterns
Published on: April 10, 2017
Pool Boiling Heat Transfer Characteristics of SiO2 and BN Nanoparticles Dispersed Mono and Hybrid Nanofluids
Wagd Ajeeb1, S M Sohel Murshed1
1IDMEC, Instituto Superior Técnico, University of Lisbon, 1049-001 Lisbon, Portugal.
Abstract:
This study reports an experimental investigation of pool boiling (PB) heat transfer performance of hybrid (two types of particles) and mono (single-particle) nanofluids consisting of Boron nitride (BN) and Silicon dioxide (SiO2) nanoparticles (NPs). While hybrid nanofluids (HNFs) were prepared in a total particle concentration of 0.05 vol.% with four different percentages of these two types of NPs (are 0.01/0.04, 0.02/ 0.03, 0.03/0.02, and 0.04/0.01 (BN vol.%/SiO2 vol.%)), two mono nanofluids (MNFs) of BN and SiO2 nanoparticles were prepared at the same total concentration of 0.05 vol.% for each NP type. Both nanofluids (NFs) were prepared in the base fluid (BF), which is the mixture of 15 vol.% of ethylene glycol (EG) and 85 vol.% of distilled water (DW). Then, the boiling heat transfer performance of these MNFs and HNFs was assessed by experimentation in a pool boiling test rig. The obtained results demonstrated good improvements in critical heat flux (CHF) and burnout heat flux (BHF) of both types of NFs. The CHF increased by up to 80% for BN-based MNF and up to 69% for HNF at 0.04 vol.% BN, which is the maximum percentage of BN into HNF, while the lowest improvement in CHF was 48% for the SiO2-based MNF compared to the BF. Similarly, the BHF was found to increase with the increasing in the loading of BN nanoparticles and a maximum enhancement of BHF of 103% for BN-based MNF was observed. These HNFs and MNFs exhibited significantly improved pool boiling heat transfer performance compared to this BF, and it became lower by increasing the percentage of SiO2 NPs in the HNFs.
Related Concept Videos
Intermolecular Forces and Physical Properties
Mechanisms of Heat Transfer II
Mechanisms of Heat Transfer I
Mechanisms of Heat Transfer
Conduction, accounting for approximately 3% of body heat loss at rest, is the process of exchanging heat between molecules of two materials in direct contact. This can result in both heat loss and gain. For instance, when the body is submerged in water, which conducts heat 20 times more effectively than air, it can either lose or gain significant...
Mechanism of heat transfer
Comparing Intermolecular Forces: Melting Point, Boiling Point, and Miscibility
Temporary attractive forces like dispersion are present in all molecules, whether they are polar or nonpolar. They...

